Home › Drivetrain › U241E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSAXLE UNIT
RM24M0E _52 Drivetrain _059578 U241E AUTOMATIC TRANSMISSION / TRANSAXLE _0292088 AUTOMATIC TRANSAXLE UNIT G

U241E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE UNIT  INSPECTION  


PROCEDURE

Hide 35106D 1.INSPECT AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

a.
AT00103

Remove the magnets and use them to collect any steel chips. Examine the clips and particles in the pan and on the magnet to determine what type of wear has occurred in the transaxle.

Steel (magnetic): bearing, gear and plate wear

Brass (non-magnetic): bush wear


Hide 2.INSPECT INPUT SHAFT END PLAY

a.

Fix the transaxle case with the oil pump side facing up.


b.
D008046

Using a dial indicator, measure the input shaft end play.

Standard end play:

0.26 to 1.25 mm (0.0103 to 0.0492 in.)



Hide 34262 3.INSPECT NO. 2 UNDERDRIVE CLUTCH DISC

Check to see if the sliding surface of the disc, plate and flange are worn or burnt.

D009196

If necessary, replace them.

NOTICE:
·

If the lining of the disc is peeling off or discolored, or even if a part of the groove is defaced, replace all discs.

·

Before assembling new discs, soak them in ATF for at least 15 minutes.



Hide 34207 4.INSPECT UNDERDRIVE BRAKE RETURN SPRING SUB-ASSEMBLY

a.
D003806

Using a vernier caliper, measure the free length of the underdrive brake return spring together with the spring seat.

Standard free length:

14.04 mm (0.5213 in.)



Hide 35677 5.INSPECT 2ND BRAKE CLUTCH DISC

a.
D004083

Check to see if the sliding surface of the disc, plate and flange are worn or burnt.

If necessary, replace them.

NOTICE:
·

If the lining of the disc is peeling off or discolored, or even if a part of the printed number is defaced, replace all discs.

·

Before assembling new discs, soak them in ATF for at least 15 minutes.




Hide 35677A 6.INSPECT 1ST AND REVERSE BRAKE CLUTCH DISC

a.
D009189

Check to see if the sliding surface of the disc, plate and flange are worn or burnt.

If necessary, replace them.

NOTICE:
·

If the lining of the disc is peeling off or discolored, or even if a part of the groove is defaced, replace all discs.

·

Before assembling new discs, soak them in ATF for at least 15 minutes.




Hide 35068 7.INSPECT 1ST AND REVERSE BRAKE RETURN SPRING SUB-ASSEMBLY

a.
D003811

Using a vernier caliper, measure the free length of the 1st and reverse brake return spring together with the spring seat.

Standard free length:

15.51 mm (0.6106 in.)



Hide 35631 8.INSPECT MULTIPLE DISC CLUTCH HUB

a.
C051677

Using a caliper gauge, measure the inside diameter of the forward clutch hub bush.

Standard inside diameter:

23.025 to 23.045 mm (0.9065 to 0.9073 in.)


Maximum inside diameter:

23.09 mm (0.9091 in.)


NOTICE:
·

When the diameter is over the maximum, replace the multiple disc clutch hub with a new one.

·

Check the contact surface of the bush in the direct clutch shaft. If any scratch or discolor is identified, replace the direct clutch sub-assembly with a new one.



If the inside diameter is greater than the maximum, replace the forward clutch hub.