1.INSPECT PACK CLEARANCE OF FORWARD CLUTCH
Install the forward clutch on the oil pump.
Be careful not to damage the oil seal ring of oil pump.
Using a dial indicator, measure the forward clutch piston stroke while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
1.74 to 2.08 mm (0.0685 to 0.0819 in.)
If the piston stroke is less than the minimum, the parts may have been assembled incorrectly. Check and reassemble again.
If the clearance is not as specified, select another flange.
There are 5 different flanges in thickness.
| No. | Thickness | No. | Thickness |
|---|---|---|---|
| 1 | 3.00 mm (0.1181 in.) | 4 | 3.45 mm (0.1358 in.) |
| 2 | 3.15 mm (0.1240 in.) | 5 | 3.60 mm (0.1417 in.) |
| 3 | 3.30 mm (0.1299 in.) | - | - |
35633B
2.INSPECT FORWARD MULTIPLE DISC CLUTCH DISC
Check to see if the sliding surface of the disc, plate and flange are worn or burnt.
If necessary, replace them.
If the lining of the disc is peeling off or discolored, replace all discs.
Before assembling new discs, soak them in ATF for at least 15 minutes.
35603A
3.INSPECT FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY
Using a vernier caliper, measure the free length of the spring together with the spring seat.
28.23 mm (1.1114 in.)
35602A
4.INSPECT FORWARD CLUTCH PISTON SUB-ASSEMBLY
Shake the piston to check that the check ball is not stuck.
Check that the value does not leak when applying low compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).