Home › Drivetrain › U241E (AUTOMATIC TRANSMISSION / TRANSAXLE) › DIRECT CLUTCH
RM24M0E _52 Drivetrain _059578 U241E AUTOMATIC TRANSMISSION / TRANSAXLE _0292092 DIRECT CLUTCH G

U241E AUTOMATIC TRANSMISSION / TRANSAXLE  DIRECT CLUTCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT PACK CLEARANCE OF DIRECT CLUTCH

a.
D009210

Install the direct clutch and needle roller bearing on the transaxle rear cover.


b.

Using a dial indicator, measure the direct clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

Standard pack clearance:

0.605 to 0.825 mm (0.0238 to 0.0325 in.)


If the pack clearance is not as specified, inspect the discs, plates and flange.


Hide 35633C 2.INSPECT DIRECT MULTIPLE DISC CLUTCH DISC

a.
D004079

Check to see if the sliding surface of the disc, plate and flange are worn or burnt.

If necessary, replace them.

HINT:
·

If the lining of the disc is peeling off or discolored, or even if a part of the printed mark is defaced, replace all discs.

·

Before assembling new discs, soak them in ATF for at least 15 minutes.




Hide 35604 3.INSPECT DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY

a.
D009211

Using a vernier caliper, measure the free length of the spring together with the spring seat.

Standard free length:

22.58 mm (0.8890 in.)