Home › Drivetrain › U241E (AUTOMATIC TRANSMISSION / TRANSAXLE) › UNDERDRIVE CLUTCH
RM24M0E _52 Drivetrain _059578 U241E AUTOMATIC TRANSMISSION / TRANSAXLE _0292094 UNDERDRIVE CLUTCH G

U241E AUTOMATIC TRANSMISSION / TRANSAXLE  UNDERDRIVE CLUTCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT UNDERDRIVE PACK CLEARANCE

a.

Install the underdrive clutch to the transaxle case.

NOTICE:

Be careful not to damage the oil seal rings.



b.
D008123

Install a dial indicator as shown in the illustration.


c.
D008124

Measure the underdrive clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

Standard pack clearance:

1.51 to 1.90 mm (0.0594 to 0.0748 in.)


If the pack clearance is not as specified, inspect the discs, plates and flange.


Hide 34261 2.INSPECT NO. 1 UNDERDRIVE CLUTCH DISC

a.
D004077

Check to see if the sliding surface of the disc, plate and flange are worn or burnt. If necessary, replace them.

HINT:
·

If the lining of the disc is peeling off or discolored, or even if a part of the printed mark is defaced, replace all discs.

·

Before assembling new discs, soak them in ATF for at least 15 minutes.




Hide 34206 3.INSPECT UNDERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY

a.
D009214

Using a vernier caliper, measure the free length of the spring together with the spring seat.

Standard free length:

17.14 mm (0.6748 in.)



Hide 34204 4.INSPECT UNDERDRIVE CLUTCH DRUM SUB-ASSEMBLY

a.
D008129

Using a caliper gauge, measure the inside diameter of the underdrive clutch drum bush.

Standard drum bush:

32.56 to 32.58 mm (1.2818 to 1.2826 in.)


Maximum drum bush:

32.63 mm (1.2846 in.)


If the inside diameter is greater than the maximum, replace the underdrive clutch drum sub-assembly.