Home › Drivetrain › U241E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSAXLE SYSTEM
RM24M0E _52 Drivetrain _059578 U241E AUTOMATIC TRANSMISSION / TRANSAXLE _0292096 AUTOMATIC TRANSAXLE SYSTEM D

U241E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  CHECK MODE PROCEDURE  


DESCRIPTION


a.

Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect all the malfunctions that normal mode can detect. In check mode, DTCs are detected with 1 trip detection logic.



CHECK MODE PROCEDURE


a.
B135940E01
0.425,2.845 1.557,3.021 1.132,0.177 10 Intelligent Tester 0.6,2.589 0.6,2.832 false 1.48,2.058 1.864,2.214 0.385,0.156 10 DLC3 1.717,2.051 1.841,1.732 false

Make sure that the following conditions below are met:

i.

Battery positive voltage is 11 V or more


ii.

Throttle valve fully closed


iii.

Transaxle in the P or N position


iv.

A/C OFF



b.

Turn the ignition switch off.


c.

Connect the intelligent tester to the DLC3.


d.

Turn the ignition switch on (IG) and turn the tester ON.


e.

Enter the following menus: Utility / Check mode.


f.
C140840E45
0.271,0.719 0.542,0.917 0.271,0.198 10 false ON 0.271,1.5 0.625,1.698 0.354,0.198 10 false OFF 2,0.448 3.01,0.646 1.01,0.198 10 false 0.13 seconds 1.885,1.771 2.781,1.969 0.896,0.198 10 false 0.13 seconds

Change the ECM to check mode. Make sure the MIL flashes as shown in the illustration.

NOTICE:

All DTCs and freeze frame data will be erased if: 1) the intelligent tester is used to change the ECM from normal mode to check mode or vice versa; or 2) during check mode, the ignition switch is turned from on (IG) to on (ACC) or off.

Before check mode, make notes of the DTCs and freeze frame data.



g.

Start the engine. The MIL should turn off after the engine starts.


h.

Perform "MONITOR DRIVE PATTERN" for the ECT test (see page Drivetrain>U241E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE SYSTEM>MONITOR DRIVE PATTERN).

(Or, simulate the conditions of the malfunction described by the customer.)


i.

After simulating the malfunction conditions, use the intelligent tester to check the DTC and freeze frame data.