Home › Drivetrain › U241E (AUTOMATIC TRANSMISSION / TRANSAXLE) › PARK / NEUTRAL POSITION SWITCH › 2013.04–2014.09
RM24M0E _52 Drivetrain _059578 U241E AUTOMATIC TRANSMISSION / TRANSAXLE _0292098 PARK / NEUTRAL POSITION SWITCH A

U241E AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 2.REMOVE BATTERY

a.

Loosen the nut, and remove the bolt and battery clamp.


b.

Remove the battery.


c.

Remove the battery tray.


d.

Detach the 2 wire harness clamps.


e.

Remove the No. 2 air cleaner inlet's bolt.


f.

Remove the 4 bolts and battery carrier.


g.

Remove the 2 bolts and battery bracket reinforcement.


Hide 84540 3.REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.
C132989

Disconnect the switch connector.


b.
C132990

Remove the nut and disconnect the control cable from the control shaft lever.


c.
C132991

Remove the nut, washer and control shaft lever.


d.
C132992

Using a screwdriver, pry off the lock plate.


e.

Remove the nut and lock plate.


f.
C132993

Remove the 2 bolts and pull out the switch.