Home › Drivetrain › U241E (AUTOMATIC TRANSMISSION / TRANSAXLE) › PARK / NEUTRAL POSITION SWITCH › from 2014.09
RM24M0E _52 Drivetrain _059578 U241E AUTOMATIC TRANSMISSION / TRANSAXLE _0292098 PARK / NEUTRAL POSITION SWITCH A

U241E AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 2.REMOVE BATTERY

a.

Loosen the nut, and remove the bolt and battery clamp sub-assembly.


b.

Remove the battery insulator.


c.

Remove the battery.


d.

Remove the battery tray.


e.

Disengage the 2 wire harness clamps.


f.

Remove the bolt and No. 2 air cleaner inlet.


g.

Remove the 4 bolts and battery carrier support.


h.

Remove the 2 bolts and battery carrier bracket.


Hide 84540 3.REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.
C310476

Disconnect the park/neutral position switch assembly connector.


b.
C310477

Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.


c.
C222545

Remove the clip and separate the transmission control cable assembly from the No. 1 transmission control cable bracket.


d.
C310478

Remove the nut, washer and control shaft lever from the manual valve lever shaft.


e.
C222549

Pry out the lock plate and remove the lock nut and lock plate from the park/neutral position switch assembly.


f.
C222551

Remove the 2 bolts and park/neutral position switch assembly from the automatic transaxle assembly.