Home › Drivetrain › U241E (AUTOMATIC TRANSMISSION / TRANSAXLE) › TRANSMISSION WIRE
RM24M0E _52 Drivetrain _059578 U241E AUTOMATIC TRANSMISSION / TRANSAXLE _0292099 TRANSMISSION WIRE A

U241E AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION WIRE  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 51441 2.REMOVE NO. 1 ENGINE UNDER COVER

Hide 3.DRAIN AUTOMATIC TRANSAXLE FLUID

a.

Remove the drain plug and gasket, and drain ATF.


b.

Install a new gasket and the drain plug.

Torque:
49 N*m (500 kgf*cm, 36 ft.*lbf)


Hide 35106D 4.REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

C083111

a.

Remove the 18 bolts, oil pan and gasket.

NOTICE:

Some fluid will remain in the oil pan. Carefully remove the oil pan.



b.

Remove the 3 magnets from the oil pan.


c.
AT00103

Examine particles in the pan.

i.

Use the removed magnets to collect any steel chips. Look carefully at the chips and particles in the pan and on the magnet to anticipate what type of wear you will find in the transaxle.

Steel (magnetic): bearing, gear and plate wear

Brass (non-magnetic): bush wear



Hide 82125J 5.REMOVE TRANSMISSION WIRE

a.

Disconnect the 5 shift solenoid valve connectors.


b.
D025591E13
2.594,0.438 2.531,0.438 false 2.531,0.438 2.531,1.302 false 2.635,0.344 3.313,0.5 0.677,0.156 10 false Lock Plate

Remove the bolt, lock plate and ATF temperature sensor.


c.
C132997

Disconnect the transmission wire connector.


d.

Remove the bolt and transmission wire.


e.
C367490

Remove the O-ring from the transmission wire.