1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2.REMOVE BATTERY
Loosen the nut, and remove the bolt and battery clamp.
Remove the battery.
Remove the battery tray.
Detach the 2 wire harness clamps.
Remove the No. 2 air cleaner inlet's bolt.
Remove the 4 bolts and battery carrier.
Remove the 2 bolts and battery bracket reinforcement.
89411C
3.REMOVE SPEED SENSOR NT
Disconnect the sensor connector.
Remove the bolt and sensor.
Remove the O-ring from the sensor.
89411C
4.REMOVE SPEED SENSOR NC
Disconnect the sensor connector.
Remove the bolt and sensor.
Remove the O-ring from the sensor.