Home › Drivetrain › U660E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSAXLE SYSTEM
RM24M0E _52 Drivetrain _059579 U660E AUTOMATIC TRANSMISSION / TRANSAXLE _0292111 AUTOMATIC TRANSAXLE SYSTEM D

U660E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  MANUAL SHIFTING TEST  


PERFORM MANUAL SHIFTING TEST


HINT:
·

With this test, it can be determined whether trouble occurs in the electrical circuit or is a mechanical problem in the transaxle.

·

If any abnormalities are found in the following test, the problem is in the transaxle itself.



a.
C157352

Disconnect the TCM connector.


b.

Drive the vehicle with the TCM disconnected.

Shift the shift lever to the D position to check whether the shifting condition changes as shown in the table below.

Shift Position Shifting Condition
D No Shift (No Change)

HINT:

When driving the vehicle with the TCM disconnected, the gear position will be as follows:

·

When the shift lever is in the D position, the transmission will stay in 3rd gear.

·

When the shift lever is in the R or P position, the transmission will also be in the R or P position respectively.




c.

Connect the TCM connector.