Home › Drivetrain › U660E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSAXLE SYSTEM
RM24M0E _52 Drivetrain _059579 U660E AUTOMATIC TRANSMISSION / TRANSAXLE _0292111 AUTOMATIC TRANSAXLE SYSTEM C

U660E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  P2769  Short in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL)  P2770  Open in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL)  


DESCRIPTION

The shift solenoid valve SL is turned ON or OFF by signals from the TCM to control the hydraulic pressure acting on the lock-up relay valve, which then controls operation of the lock-up clutch.

DTC No. DTC Detection Condition Trouble Area
P2769 TCM detects a short in the shift solenoid valve SL circuit when the shift solenoid valve SL is operated (2-trip detection logic)
·

Short in shift solenoid valve SL circuit

·

Shift solenoid valve SL

·

TCM


P2770 TCM detects an open in the shift solenoid valve SL circuit when the shift solenoid valve SL is not operated (2-trip detection logic)
·

Open in shift solenoid valve SL circuit

·

Shift solenoid valve SL

·

TCM



Fail-safe function:

If the TCM detects a malfunction, it turns the shift solenoid valve SL OFF.

MONITOR DESCRIPTION

Based on the signals from the throttle position sensor, the air flow meter and the crankshaft position sensor, the TCM sends a signal to the solenoid valve SL to regulate the hydraulic pressure and provide smoother torque converter assembly engagement. The shift solenoid valve SL responds to commands from the TCM. The valve controls the lock-up relay valve to perform the torque-converter lock-up function. If the TCM detects an open or short circuit in the shift solenoid valve SL, it will illuminate the MIL.

WIRING DIAGRAM

C133259E09
5.094,1.688 5.635,1.854 0.542,0.167 10 false SL 5.635,0.542 5.99,0.865 0.354,0.323 10 false TCM 1.583,2.552 3.635,2.74 2.052,0.188 10 false Shift Solenoid Valve SL 2.135,3.844 3.51,4.25 1.375,0.406 10 false Transaxle Assembly 4.865,1.563 5.021,1.74 0.156,0.177 10 false 6

PROCEDURE

1.INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SL)
a.
C133212E09
2.26,0.355 2.459,0.504 0.199,0.149 10 SL 1.914,0.726 2.242,0.454 false

Remove the TCM from the transaxle.


b.

Measure the resistance of the transmission wire.

Standard resistance:
Tester Connection Condition Specified Condition
6 (SL) - Body ground 20°C (68°F) 11 to 15 Ω




NG

2.INSPECT SHIFT SOLENOID VALVE SL (RESISTANCE)

OK

REPLACE TCM

2.INSPECT SHIFT SOLENOID VALVE SL (RESISTANCE)
a.

Remove the shift solenoid valve SL.


C133217

b.

Measure the resistance between the solenoid valve terminal and solenoid valve body.

Standard resistance:

11 to 15 Ω at 20°C (68°F)




OK

REPLACE TRANSMISSION WIRE

NG

REPLACE SHIFT SOLENOID VALVE SL