ATF pressure switch No. 3 is installed in the lockup solenoid ATF output passage and is used to detect a malfunction in the lockup solenoid.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0989 | Transmission fluid pressure switch No. 3 is OFF when lock-up occurs in response to a lock-up request (2-trip detection logic). | ·
ATF temperature sensor assembly (ATF pressure switch No. 3) ·
Transmission wire ·
TCM |
| P0990 | When both of the following are detected (2-trip detection logic):
·
Transmission fluid pressure switch No. 3 is ON when lock-up does not occur. ·
Lock-up does not occur when shift solenoid valve (SLU) is requested to turn off in the lock-up range. |
The TCM illuminates the MIL and stores the DTC when the TCM detects that the ATF pressure switch is OFF with the lock-up solenoid ON or when the TCM detects that the ATF pressure switch is ON with the lock-up solenoid OFF.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester on.
Enter the following items: "Powertrain / ECT / DTC / Current or Pending".
Read the DTCs using the intelligent tester.
| Display (DTC output) | Proceed to |
|---|---|
| Only "P0990" is output | A |
| Only "P0989" is output | B |
| "P0989 or P0990" and other DTCs are output | C |
If a solenoid is stuck OFF, DTCs for several solenoids including the malfunctioning solenoid will be detected.
A
B
C
Remove the TCM.
Measure the resistance according to the value(s) in the table below.
| Tester Condition | Specified Condition |
|---|---|
| 19 (TPS3) - Body ground (Valve body assembly) | 10 kΩ or higher |
NG
OK
Disconnect the connector from the ATF temperature sensor assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Condition | Specified Condition |
|---|---|
| 5 (TPS3) - Body ground (Valve body assembly) | 10 kΩ or higher |
OK
NG
Remove the TCM.
Disconnect the speed sensor connector from the transmission wire.
Measure the resistance according to the value(s) in the table below.
| Tester Condition | Specified Condition |
|---|---|
| 19 (TPS3) - 5 (TPS3) | Below 1 Ω |
| 19 (TPS3) or 5 (TPS3) - Body ground (Valve body assembly) | 10 kΩ or higher |
OK
NG