Home › Drivetrain › U660E (AUTOMATIC TRANSMISSION / TRANSAXLE) › SHIFT LOCK SYSTEM
RM24M0E _52 Drivetrain _059579 U660E AUTOMATIC TRANSMISSION / TRANSAXLE _0292117 SHIFT LOCK SYSTEM G

U660E AUTOMATIC TRANSMISSION / TRANSAXLE  SHIFT LOCK SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK SHIFT LOCK OPERATION

a.

Move the shift lever to the P position.


b.

Turn the engine switch off.


c.

Check that the shift lever cannot be moved to any position other than P.


d.

Turn the engine switch on (IG), depress the brake pedal and check that the shift lever can be moved to another position.

If operation cannot be done as specified, inspect the shift lock control unit.


Hide 33563 2.CHECK SHIFT LOCK RELEASE BUTTON OPERATION

a.

Using a screwdriver, remove the shift lock release cover.


b.

When operating the shift lever with the shift lock release button pressed, check that the lever can be moved to any position other than P.

If operation cannot be done as specified, check the shift lever assembly installation condition.


Hide 3.INSPECT SHIFT LOCK CONTROL UNIT ASSEMBLY

a.
C129009E05
0.185,0.184 0.979,0.398 0.794,0.214 10 Switch Side: 0.595,2.775 0.788,2.927 0.193,0.151 10 IG 0.476,1.194 0.776,1.345 0.299,0.151 10 STP 1.905,1.022 2.065,1.173 0.161,0.151 10 E 1.144,2.284 0.731,2.748 false 1.111,1.795 0.663,1.394 false 1.965,1.209 1.855,1.772 false

Measure the voltage according to the value(s) in the table below.

HINT:

Do not disconnect the shift lock control unit assembly connector.


Standard voltage:
Tester Connection Condition Specified Condition
12 (IG) - 3 (E) Engine switch on (IG) 10 to 14 V
Engine switch off Below 1 V
6 (STP) - 3 (E) Brake pedal depressed 10 to 14 V
Brake pedal released Below 1 V



b.
C129009E06
0.161,0.159 0.968,0.373 0.808,0.214 10 Switch Side: 1.905,1.041 2.065,1.192 0.161,0.151 10 E 1.965,1.227 1.855,1.79 false

Measure the resistance according to the value(s) in the table below.

HINT:

Do not disconnect the shift lock control unit assembly connector.


Standard resistance:
Tester Connection Condition Specified Condition
3 (E) - Body ground Always Below 1 Ω


If the result is not as specified, replace the shift lever assembly.