Home › Drivetrain › U660E (AUTOMATIC TRANSMISSION / TRANSAXLE) › OIL PUMP
RM24M0E _52 Drivetrain _059579 U660E AUTOMATIC TRANSMISSION / TRANSAXLE _0292125 OIL PUMP G

U660E AUTOMATIC TRANSMISSION / TRANSAXLE  OIL PUMP  INSPECTION  


PROCEDURE

Hide 35035 1.INSPECT FRONT OIL PUMP AND GEAR BODY SUB-ASSEMBLY

a.
C138512

Turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.

NOTICE:

Be careful not to damage the oil seal lip.



Hide 35035 2.INSPECT CLEARANCE OF FRONT OIL PUMP AND GEAR BODY SUB-ASSEMBLY

a.
C138509

Push the driven gear to one side of the body.


b.

Using a feeler gauge, measure the clearance.

Standard clearance:

0.08 to 0.15 mm (0.0031 to 0.0059 in.)


Maximum clearance:

0.15 mm (0.0059 in.)


If the clearance is greater than the maximum, replace the front oil pump and gear body sub-assembly.


c.
C138511

Using a straightedge and feeler gauge, measure the side clearance of both gears.

Standard side clearance:

0.035 to 0.05 mm (0.00138 to 0.00197 in.)


Maximum side clearance:

0.05 mm (0.00197 in.)

Drive gear thickness:
Mark Thickness
- 11.547 to 11.555 mm (0.4546 to 0.4549 in.)
- 11.555 to 11.563 mm (0.4549 to 0.4552 in.)
- 11.564 to 11.571 mm (0.4553 to 0.4556 in.)
- 11.572 to 11.579 mm (0.4556 to 0.4559 in.)
- 11.580 to 11.587 mm (0.4559 to 0.4562 in.)

Driven gear thickness:
Mark Thickness
- 11.547 to 11.555 mm (0.4546 to 0.4549 in.)
- 11.555 to 11.563 mm (0.4549 to 0.4552 in.)
- 11.564 to 11.571 mm (0.4553 to 0.4556 in.)
- 11.572 to 11.579 mm (0.4556 to 0.4559 in.)
- 11.580 to 11.587 mm (0.4559 to 0.4562 in.)



Hide 35035 3.INSPECT FRONT OIL PUMP AND GEAR BODY SUB-ASSEMBLY

a.
C138514

Using a dial indicator, measure the inside diameter of the front oil pump and gear body sub-assembly bushing.

Standard inside diameter:

43.113 to 43.138 mm (1.6974 to 1.6983 in.)


Maximum inside diameter:

43.188 mm (1.7003 in.)


If the inside diameter is greater than the maximum, replace the front oil pump and gear body sub-assembly.


Hide 35370 4.INSPECT STATOR SHAFT ASSEMBLY

a.
C138513

Using a dial indicator, measure the inside diameter of the front oil pump and gear body sub-assembly bushing.

Standard inside diameter:

22.500 to 22.526 mm (0.8858 to 0.8868 in.)


Maximum inside diameter:

22.570 mm (0.8886 in.)


If the inside diameter is greater than the maximum, replace the front oil pump and gear body sub-assembly.