43502C
1.CHECK FRONT AXLE HUB BEARING
Remove the front wheel.
Remove the front disc brake caliper (see page Brake>BRAKE>FRONT BRAKE(for 16 inch Front Disc Brake)>REMOVAL).
Remove the front disc.
Inspect the axle hub backlash.
Using a dial indicator, measure the backlash near the center of the axle hub.
0.05 mm (0.0020 in.)
If the backlash is greater than the maximum, replace the bearing.
Inspect the axle hub deviation.
Using a dial indicator, measure the deviation on the surface of the axle hub.
0.05 mm (0.0020 in.)
If the deviation is greater than the maximum, replace the bearing.