Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1.REMOVE REAR WHEEL
48540
2.REMOVE REAR SHOCK ABSORBER ASSEMBLY LH
Support the axle beam with a jack.
Place a wooden or rubber block between the jack and axle beam.
Remove the nut and bolt from the axle beam.
While fixing the nut in place, loosen and remove the bolt.
64735G
3.REMOVE DECK TRIM SIDE SERVICE HOLE COVER LH
Using a screwdriver, remove the hole cover.
Tape the screwdriver tip before use.
48554A
4.REMOVE REAR SHOCK ABSORBER CAP LH
Remove the cap from the shock absorber.
48750A
5.REMOVE REAR SUPPORT TO REAR SHOCK ABSORBER NUT
Remove the nut from the shock absorber.
48530P
6.REMOVE REAR SHOCK ABSORBER CUSHION RETAINER
Remove the retainer from the shock absorber.
48530G
7.REMOVE REAR NO. 1 SHOCK ABSORBER CUSHION
Remove the cushion from the shock absorber.