Home › Suspension › SUSPENSION › REAR AXLE BEAM
RM24M0E _53 Suspension _059582 SUSPENSION _0292147 REAR AXLE BEAM A

SUSPENSION  REAR AXLE BEAM  DISASSEMBLY  


PROCEDURE

Hide 48725G 1.REMOVE REAR AXLE CARRIER BUSH LH

a.

Place a matchmark as shown in the illustration.

HINT:

Put a matchmark on the rear axle beam where it aligns with the bushing cutout.



b.

Using a clipper, make a cutout following the arrow position on the bushing.


c.

Using a chisel and hammer, fold the 2 bushing rims (see the illustration below).

NOTICE:

Fold the bushing rims to fit the claw No. 5 (09955-04051).



d.

Using SST, remove the rear axle carrier bush from the rear axle beam.

SST
09950-40011  (09951-04020, 09952-04010, 09953-04030, 09954-04020, 09955-04051, 09957-04010, 09958-04011)
09950-60010  (09951-00630)

NOTICE:
·

Do not erase the matchmark on the rear axle beam when removing the bushing.

·

Set SST to center the bolt in the bushing.

·

If there are any scratches on the rear axle beam, apply chassis black.

U186074E02
1.177,2.458 0.719,3.365 0.719,3.365 1.792,3.094 false 1.833,0.927 2.688,0.927 true 5.031,0.677 4.552,0.677 false 5.552,0.906 6.104,0.906 false 1.833,1 2.573,1.438 true 2.74,0.854 3.479,1.01 0.74,0.156 10 false Matchmark 0.177,3.396 1.073,3.563 0.896,0.167 10 false Bend Portions 4.24,0.594 4.542,0.74 0.302,0.146 10 false SST 6.135,0.833 6.438,0.979 0.302,0.146 10 false SST 2.427,1.417 3.073,1.583 0.646,0.167 10 false Projection




Hide 48725F 2.REMOVE REAR AXLE CARRIER BUSH RH

HINT:

Use the same procedures described for the LH side.