Home › Suspension › SUSPENSION › REAR AXLE BEAM
RM24M0E _53 Suspension _059582 SUSPENSION _0292147 REAR AXLE BEAM A

SUSPENSION  REAR AXLE BEAM  REASSEMBLY  


PROCEDURE

Hide 48725G 1.INSTALL REAR AXLE CARRIER BUSH LH

a.

Temporarily install a new bushing, aligning it with the matchmark on the rear axle beam.

HINT:

Align the matchmarks on the rear axle beam with the bushing cutout prior to temporary installation of a new bushing.


NOTICE:

A bushing operates in a specific direction. Install the bushing in the same direction as it was prior to removal.



b.

Apply MP grease No. 2 to the bolt heads and washers.


c.

Using SST, install the rear axle carrier bush to the rear axle beam.

SST
09710-28031  (09711-02010, 09711-02020, 09711-02030, 09711-02040, 94622-51200)

NOTICE:

Be careful not to damage the rubber part of the bushing when installing it.


C196054E01
0.471,0.882 1.215,1.035 0.744,0.153 10 Matchmark 2.037,0.253 2.332,0.393 0.295,0.140 10 SST 1.03,2.951 1.825,3.104 0.795,0.152 10 Rubber Part 1.42,2.545 1.42,2.938 false 1.849,2.66 2.498,2.812 0.649,0.152 10 Projection 3.701,2.904 3.996,3.044 0.295,0.140 10 SST 3.838,2.46 3.838,2.901 false 2.497,1.427 2.497,0.322 2.497,0.322 2.338,0.322 false 1.4,1.729 1.4,0.955 1.4,0.955 1.205,0.955 false 1.352,1.84 2.157,2.646 false


Hide 48725F 2.INSTALL REAR AXLE CARRIER BUSH RH

HINT:

Use the same procedures described for the LH side.