Home › Suspension › SUSPENSION › FRONT STABILIZER BAR(for 2AZ-FE)
RM24M0E _53 Suspension _059582 SUSPENSION _0292149 FRONT STABILIZER BAR(for 2AZ-FE) G

SUSPENSION  FRONT STABILIZER BAR(for 2AZ-FE)  INSPECTION  


PROCEDURE

Hide 48810 1.INSPECT FRONT STABILIZER LINK ASSEMBLY LH

C133574

a.

Move the ball joint stud back and forth 5 times as shown in the illustration, before installing the nut.


b.

Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.

Turning torque:

0.05 to 1.96 N*m, (0.5 to 20 kgf*cm, 0.4 to 17 in.*lbf) or less



c.

Check for any cracks and grease leaks on the ball joint dust cover.