Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
48158C
1.INSTALL FRONT COIL SPRING INSULATOR LOWER LH
Shock Absorber Type A:
Install the insulator lower to the shock absorber.
Shock Absorber Type B:
Install the insulator lower to the shock absorber.
When installing the front lower coil spring insulator, make sure that the front lower coil spring insulator does not get caught on the claws of the front shock absorber assembly.
| *a | Claw |
48331C
2.INSTALL FRONT SPRING BUMPER LH
Install the spring bumper to the shock absorber.
48132
3.INSTALL FRONT COIL SPRING LH
Secure SST in a vise.
Attach the arms of SST to the diameter of the front coil spring.
Make sure that the front coil spring is installed so that the distance between the upper and lower arms of SST is at the maximum.
Make sure that the claws of the arms are securely attached.
Using SST, compress the front coil spring.
If the front coil spring bends during compression, immediately stop compression and reinstall SST.
Do not excessively compress the front coil spring so that the coils contact each other.
Do not use an impact wrench. It will damage SST.
Install the front coil spring to the front shock absorber assembly.
Make sure that the end of the front coil spring is positioned in the depression of the front lower spring insulator.
48157C
4.INSTALL FRONT COIL SPRING INSULATOR UPPER LH (Shock Absorber Type A)
Install the insulator upper to the shock absorber.
48471C
5.INSTALL FRONT COIL SPRING SEAT UPPER LH (Shock Absorber Type A)
6.INSTALL FRONT SPRING SEAT SUB-ASSEMBLY WITH INSULATOR LH (Shock Absorber Type B)
Install the front spring seat sub-assembly with insulator to the front shock absorber assembly.
The lower end of the front spring seat sub-assembly with insulator will engage with the claws of the front shock absorber assembly when the suspension is stabilized.
48619A
7.INSTALL STRUT MOUNTING BEARING LH
Install the mounting bearing to the insulator upper.
48609
8.INSTALL FRONT SUSPENSION SUPPORT SUB-ASSEMBLY LH
Install the suspension support to the shock absorber.
9.INSTALL COLLAR
Install the collar to the suspension support side.
48680A
10.INSTALL FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT
Temporarily tighten a new front support to front shock absorber nut.
Remove SST from the front coil spring.
Do not use an impact wrench. It will damage SST.
48687B
11.INSTALL FRONT SUSPENSION SUPPORT PLATE LH
Install the support plate to the shock absorber with coil spring.