Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2.REMOVE FRONT WHEEL
53876A
3.REMOVE FRONT FENDER LINER LH
89543
4.REMOVE FRONT SPEED SENSOR LH
Disconnect the sensor connector (labeled A).
Remove the sensor clip (labeled B).
Remove the sensor clip (labeled C), bolt (labeled D) and sensor clamp (labeled E).
Remove the sensor clip (labeled F), bolt (labeled G) and sensor clamp (labeled H).
Remove the bolt and sensor body from the knuckle.
Keep the sensor tip and sensor installation hole free from foreign matter.