READ DATA LIST
Using the intelligent tester's Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| ABS Warning Light | ABS warning light / ON or OFF | ON: ABS warning light ON
OFF: ABS warning light OFF |
- |
| Brake Warning Light | Brake warning light / ON or OFF | ON: Brake warning light ON
OFF: Brake warning light OFF |
- |
| Stop Light SW | Stop light switch / ON or OFF | ON: Brake pedal depressed
OFF: Brake pedal released |
- |
| Parking Brake SW | Parking brake switch / ON or OFF | ON: Parking brake applied
OFF: Parking brake released |
- |
| FR Wheel Speed | Wheel speed sensor (FR) reading / Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202.8 mph) | Actual wheel speed | Similar to speed indicated on speedometer |
| FL Wheel Speed | Wheel speed sensor (FL) reading / Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202.8 mph) | Actual wheel speed | Similar to speed indicated on speedometer |
| RR Wheel Speed | Wheel speed sensor (RR) reading / Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202.8 mph) | Actual wheel speed | Similar to speed indicated on speedometer |
| RL Wheel Speed | Wheel speed sensor (RL) reading / Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202.8 mph) | Actual wheel speed | Similar to speed indicated on speedometer |
| Vehicle Speed | Maximum speed sensor reading / Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202.8 mph) | Actual wheel speed | Similar to speed indicated on speedometer |
| FR Wheel Acceleration | FR wheel acceleration / Min.: -200.84 m/s2, Max.: 199.27 m/s2 | Min.: -200.84 m/s2
Max.: 199.27 m/s2 |
- |
| FL Wheel Acceleration | FL wheel acceleration / Min.: -200.84 m/s2, Max.: 199.27 m/s2 | Min.: -200.84 m/s2
Max.: 199.27 m/s2 |
- |
| RR Wheel Acceleration | RR wheel acceleration / Min.: -200.84m/s2, Max.: 199.27 m/s2 | Min.: -200.84 m/s2
Max.: 199.27 m/s2 |
- |
| RL Wheel Acceleration | RL wheel acceleration / Min.: -200.84 m/s2, Max.: 199.27 m/s2 | Min.: -200.84 m/s2
Max.: 199.27 m/s2 |
- |
| FR Wheel ABS Ctrl Status | FR wheel ABS control status / ON or OFF | ON: ABS operating
OFF: ABS not operating |
- |
| FL Wheel ABS Ctrl Status | FL wheel ABS control status / ON or OFF | ON: ABS operating
OFF: ABS not operating |
- |
| RR Wheel ABS Ctrl Status | RR wheel ABS control status / ON or OFF | ON: ABS operating
OFF: ABS not operating |
- |
| RL Wheel ABS Ctrl Status | RL wheel ABS control status / ON or OFF | ON: ABS operating
OFF: ABS not operating |
- |
| RR Wheel EBD Ctrl Status | RR wheel EBD control status / ON or OFF | ON: EBD operating
OFF: EBD not operating |
- |
| RL Wheel EBD Ctrl Status | RL wheel EBD control status / ON or OFF | ON: EBD operating
OFF: EBD not operating |
- |
| Solenoid Relay | Solenoid relay / ON or OFF | ON: Solenoid relay ON
OFF: Solenoid relay OFF |
- |
| Electronically Controlled Brake System Motor Relay | ABS Motor relay / ON or OFF | ON: Motor relay ON
OFF: Motor relay OFF |
- |
| ABS Solenoid (SFRH)*1 | ABS solenoid (SFRH) / ON or OFF | ON: Operates
OFF: Does not operate |
- |
| ABS Solenoid (SFRR)*2 | ABS solenoid (SFRR) / ON or OFF | ON: Operates
OFF: Does not operate |
- |
| ABS Solenoid (SFLH)*3 | ABS solenoid (SFLH) / ON or OFF | ON: Operates
OFF: Does not operate |
- |
| ABS Solenoid (SFLR)*4 | ABS solenoid (SFLR) / ON or OFF | ON: Operates
OFF: Does not operate |
- |
| ABS Solenoid (SRRH)*5 | ABS solenoid (SRRH) / ON or OFF | ON: Operates
OFF: Does not operate |
- |
| ABS Solenoid (SRRR)*6 | ABS solenoid (SRRR) / ON or OFF | ON: Operates
OFF: Does not operate |
- |
| ABS Solenoid (SRLH)*7 | ABS solenoid (SRLH) / ON or OFF | ON: Operates
OFF: Does not operate |
- |
| ABS Solenoid (SRLR)*8 | ABS solenoid (SRLR) / ON or OFF | ON: Operates
OFF: Does not operate |
- |
| FR Speed Open | FR speed sensor open detection / ERROR or NORMAL | ERROR: Momentary interruption
NORMAL: Normal |
- |
| FL Speed Open | FL speed sensor open detection / ERROR or NORMAL | ERROR: Momentary interruption
NORMAL: Normal |
- |
| RR Speed Open | RR speed sensor open detection / ERROR or NORMAL | ERROR: Momentary interruption
NORMAL: Normal |
- |
| RL Speed Open | RL speed sensor open detection / ERROR or NORMAL | ERROR: Momentary interruption
NORMAL: Normal |
- |
| Number of DTC | Number of recorded DTCs / Min.: 0, Max.: 255 | Min.: 0
Max.: 255 |
- |
*1: SFRH (S: Solenoid, F: Front, R: Right, H: Holding)
*2: SFRR (S: Solenoid, F: Front, R: Right, R: Reduction)
*3: SFLH (S: Solenoid, F: Front, L: Left, H: Holding)
*4: SFLR (S: Solenoid, F: Front, L: Left, R: Reduction)
*5: SRRH (S: Solenoid, R: Rear, R: Right, H: Holding)
*6: SRRR (S: Solenoid, R: Rear, R: Right, R: Reduction)
*7: SRLH (S: Solenoid, R: Rear, L: Left, H: Holding)
*8: SRLR (S: Solenoid, R: Rear, L: Left, R: Reduction)
PERFORM ACTIVE TEST
Performing the intelligent tester's Active Test allows relays, VSVs, actuators and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to save time. The Data List can be displayed during the Active Test.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.
According to the display on the intelligent tester, perform the Active Test.
The engine switch must be turned on (IG) to proceed to the Active Test using the intelligent tester.
The Active Tests of the ABS solenoid, ABS motor relay, ABS warning light and brake warning light are available when the vehicle is stopped.
The motors stop automatically after 5 seconds of activation to prevent them from being damaged. When the motors are driven repeatedly, certain intervals are required.
Each solenoid stops automatically after 2 seconds of activation to prevent them from being damaged, and can be operated again after a certain interval.
Do not depress the brake pedal while only the pressure reduction solenoid valves are on.
Do not drive 2 or more solenoids simultaneously except to operate the pressure holding solenoid valves and pressure reduction solenoid valves of each wheel.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| ABS Warning Light | ABS warning light | Warning light ON/OFF | Observe combination meter |
| Brake Warning Light | Brake warning light | Warning light ON/OFF | Observe combination meter |
| Solenoid Relay | ABS solenoid relay | Relay ON/OFF | Perform the Active Test and check for DTCs. If no codes are output, the solenoid relay is operating normally |
| Motor Relay | ABS motor relay | Relay ON/OFF | Operation sound of motor can be heard |
| ABS Solenoid (SRLR) | ABS solenoid (SRLR) | Solenoid ON/OFF | Operation sound of solenoid (clicking sound) can be heard |
| ABS Solenoid (SRLH) | ABS solenoid (SRLH) | Solenoid ON/OFF | Operation sound of solenoid (clicking sound) can be heard |
| ABS Solenoid (SRRR) | ABS solenoid (SRRR) | Solenoid ON/OFF | Operation sound of solenoid (clicking sound) can be heard |
| ABS Solenoid (SRRH) | ABS solenoid (SRRH) | Solenoid ON/OFF | Operation sound of solenoid (clicking sound) can be heard |
| ABS Solenoid (SFLR) | ABS solenoid (SFLR) | Solenoid ON/OFF | Operation sound of solenoid (clicking sound) can be heard |
| ABS Solenoid (SFLH) | ABS solenoid (SFLH) | Solenoid ON/OFF | Operation sound of solenoid (clicking sound) can be heard |
| ABS Solenoid (SFRR) | ABS solenoid (SFRR) | Solenoid ON/OFF | Operation sound of solenoid (clicking sound) can be heard |
| ABS Solenoid (SFRH) | ABS solenoid (SFRH) | Solenoid ON/OFF | Operation sound of solenoid (clicking sound) can be heard |