Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › 2013.04–2014.09
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292157 ANTI-LOCK BRAKE SYSTEM D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  CHECK FOR INTERMITTENT PROBLEMS  


CHECK FOR INTERMITTENT PROBLEMS


HINT:

A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be detected by using the ECU Data List function of the intelligent tester.


a.

Turn the engine switch off and connect the intelligent tester to the DLC3.


b.

Turn the engine switch on (IG).


c.

Follow the prompts on the intelligent tester to display the Data List and select areas where a momentary interruption should be monitored.

HINT:
·

A momentary interruption (open circuit) cannot be detected for 3 seconds after the engine switch is turned on (IG) (initial check).

·

If the status remains on the ERROR display, check for continuity between the ECU and the sensors, or between ECUs.

·

The ERROR display on the intelligent tester remains on for 1 second after the harness signal changes from a momentary interruption (open circuit) to the normal condition.



ABS/VSC/TRC
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
FR Speed Open FR speed sensor open detection / ERROR or NORMAL ERROR: Momentary interruption
NORMAL: Normal
-
FL Speed Open FL speed sensor open detection / ERROR or NORMAL ERROR: Momentary interruption
NORMAL: Normal
-
RR Speed Open RR speed sensor open detection / ERROR or NORMAL ERROR: Momentary interruption
NORMAL: Normal
-
RL Speed Open RL speed sensor open detection / ERROR or NORMAL ERROR: Momentary interruption
NORMAL: Normal
-
Deceleration Open* Deceleration sensor open detection / ERROR or NORMAL ERROR: Momentary interruption
NORMAL: Normal
-

*: for CVT


d.

While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs.

OK:

ERROR display does not change.


HINT:

The connector and/or wire harness have a momentary interruption (open circuit) if the display changes. Repair or replace the connector and wire harness if either of them is faulty.