Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2016.05
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292158 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1433  Steering Angle Sensor Internal Circuit  


DESCRIPTION

This DTC is stored when the skid control ECU (brake actuator assembly) receives an internal malfunction signal from the steering angle sensor.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1433 Steering Angle Sensor Internal Circuit With the +BS terminal voltage between 9.6 and 16.5 V, a steering angle sensor malfunction signal is received from the steering angle sensor. Steering angle sensor

PROCEDURE

1.REPLACE STEERING ANGLE SENSOR
a.

Replace the steering angle sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>STEERING ANGLE SENSOR>REMOVAL).

HINT:

If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE).




NEXT

END