Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2013.04–2014.09
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292158 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1448/98  Yaw Rate Sensor Output Malfunction  


DESCRIPTION

The skid control ECU receives signals from the yaw rate sensor via the CAN communication system.

The yaw rate sensor has a built-in deceleration sensor and detects the vehicle condition.

DTC No. DTC Detection Condition Trouble Area
C1448/98 When the vehicle speed is 20 km/h (12 mph) or more, an invalid data signal is received from the yaw rate sensor for 120 seconds or more. Yaw rate sensor

PROCEDURE

1.CHECK DTC

b.

Start and idle the engine.


c.

Drive the vehicle at a speed of 20 km/h (12 mph) or more for at least 120 seconds, and then stop the engine.


d.

Check if the same DTC is recorded (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC is output A
DTC is not output B




A

B