Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR(for 2AZ-FE without VSC) › 2013.04–2016.05
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292159 BRAKE ACTUATOR(for 2AZ-FE without VSC) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR(for 2AZ-FE without VSC)  REASSEMBLY  


PROCEDURE

Hide 44510 1.INSTALL BRAKE ACTUATOR ASSEMBLY

NOTICE:

Do not remove the hole plugs before connecting the brake lines. New actuators are filled with brake fluid.


a.

Set the actuator on the bracket.

NOTICE:
C130695E02
1.927,1.792 2.26,2.302 false 1.531,1.906 1.094,2.271 false 1.24,1.625 0.938,1.906 false 2.125,1.333 2.406,0.781 2.406,0.781 2.563,0.781 false 2.615,0.688 3.24,0.844 0.625,0.156 10 false Actuator 0.844,2.302 1.135,2.49 0.292,0.188 10 false Pin 2.042,2.323 3.01,2.5 0.969,0.177 10 false Rubber Mount 0.271,1.865 0.865,2.052 0.594,0.188 10 false Bracket

Insert the pin of the actuator into the rubber mount of the bracket securely.



b.
C130694

Install the 2 nuts to assemble the brake actuator assembly and bracket.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)