Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH › from 2016.05
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292164 VSC OFF SWITCH G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VSC OFF SWITCH  INSPECTION  


PROCEDURE

Hide 84988L 1.INSPECT VSC OFF SWITCH (for LHD)

a.
C239020E05
0.171,0.138 0.444,0.377 0.274,0.239 10 *a 1.898,2.028 2.474,2.87 false 1.527,2.028 0.952,2.87 false 2.431,2.883 2.559,3.046 0.128,0.163 10 E 0.849,2.883 0.978,3.046 0.128,0.163 10 +

Make sure that there is no looseness in the locking part and the connecting part of the connector.


b.

Disconnect the VSC OFF switch connector.


c.

Check both the connector case and the terminal for deformation and corrosion.

OK:

No deformation or corrosion.



d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (+) - 3 (E) Switch pushed in Below 1 Ω
6 (+) - 3 (E) Switch not pushed in 10 kΩ or higher

Text in Illustration
*a Component without harness connected
(VSC OFF Switch)


If the result is not as specified, replace the VSC OFF switch.


Hide 84970 2.INSPECT COMBINATION SWITCH ASSEMBLY (for RHD)

a.
C305912E01
0.159,0.112 0.338,0.285 0.179,0.173 10 *a 0.892,1.774 1.071,1.947 0.179,0.173 10 + 1.952,1.804 2.340,1.977 0.387,0.173 10 GND 1.346,1.441 1.008,1.78 false 1.605,1.421 1.932,1.817 false

Make sure that there is no looseness in the locking part and the connecting part of the connector.


b.

Disconnect the VSC OFF switch (combination switch assembly) connector.


c.

Check both the connector case and the terminal for deformation and corrosion.

OK:

No deformation or corrosion.



d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
10 (+) - 9 (GND) Switch pushed in Below 1 Ω
10 (+) - 9 (GND) Switch not pushed in 10 kΩ or higher

Text in Illustration
*a Component without harness connected
(VSC OFF Switch (Combination Switch Assembly))


If the result is not as specified, replace the VSC OFF switch (combination switch assembly).