88539K
1.REMOVE DRAIN COOLER HOSE
Remove the drain hose from rear cooling unit.
87106W
2.REMOVE AIR MIX REAR DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)
Disconnect the connector.
Remove the 2 screws and damper servo.
87106J
3.REMOVE MODE DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)
Disconnect the connector.
Remove the 2 screws and damper servo.
88716C
4.REMOVE COOLER REFRIGERANT LIQUID PIPE C
Remove the packing.
Remove the bolt and plate.
Remove the 3 screws and heater cover.
Remove the 2 screws, clamp and liquid pipe.
Remove the O-ring from the liquid pipe.
88717A
5.REMOVE COOLER REFRIGERANT SUCTION PIPE A
Remove the suction pipe.
Remove the O-ring from the suction pipe.
87249C
6.REMOVE HEATER WATER OUTLET PIPE C (for Automatic Air Conditioning System)
Remove the 3 screws and heater cover.
Remove the screw and clamp.
Remove the clip and water outlet pipe.
87248C
7.REMOVE HEATER WATER INLET PIPE C (for Automatic Air Conditioning System)
Remove the clip and water inlet pipe.
87256C
8.REMOVE REAR HEATER WATER OUTLET HOSE C (for Automatic Air Conditioning System)
Remove the clip and heater outlet hose.
87255C
9.REMOVE REAR HEATER WATER INLET HOSE C (for Automatic Air Conditioning System)
Remove the clip and heater inlet hose.
87452Q
10.REMOVE NO. 1 HEATER BRACKET
Remove the screw and No. 1 heater bracket.
11.REMOVE BRACKET (for Automatic Air Conditioning System)
Remove the 3 screws and bracket.
87107B
12.REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY (for Automatic Air Conditioning System)
Remove the screw and detach the claw.
Remove the heater clamp.
87103D
13.REMOVE BLOWER MOTOR
Remove the 3 screws and blower motor.
87138D
14.REMOVE BLOWER (REAR) RESISTOR (for Manual Air Conditioning System)
Remove the 2 screws and resistor.
87165C
15.REMOVE BLOWER MOTOR CONTROL (for Automatic Air Conditioning System)
Remove the 2 screws and resistor.
88515B
16.REMOVE REAR COOLING UNIT EXPANSION VALVE
Detach the 3 claws and remove the plate.
Using a 4 mm hexagon wrench, remove the 2 hexagon bolts.
Remove the expansion valve and grommet.
88501R
17.REMOVE EVAPORATOR SUB-ASSEMBLY
Remove the 12 screws and rear cooling unit case LH.
Remove the evaporator, as shown in the illustration.
Remove the 2 O-rings from the evaporator.
82210K
18.REMOVE EVAPORATOR TEMPERATURE SENSOR
Detach the claw and clip and remove the sensor.