82210K
1.INSTALL EVAPORATOR TEMPERATURE SENSOR
Attach the claw and clip to install the sensor.
88501R
2.INSTALL EVAPORATOR SUB-ASSEMBLY
Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the hose joint.
ND-OIL 8 or equivalent
Install the 2 O-rings to the evaporator.
Install the evaporator, as shown in the illustration.
Install the rear cooling unit case LH with the 12 screws.
88515B
3.INSTALL REAR COOLING UNIT EXPANSION VALVE
Install the expansion valve and grommet.
Using a 4 mm hexagon wrench, install the 2 hexagon bolts.
Attach the 3 claws to install the plate.
87165C
4.INSTALL BLOWER MOTOR CONTROL (for Automatic Air Conditioning System)
Install the resistor with the 2 screws.
87138D
5.INSTALL BLOWER (REAR) RESISTOR (for Manual Air Conditioning System)
Install the resistor with the 2 screws.
87103D
6.INSTALL BLOWER MOTOR
Install the blower motor with the 3 screws.
87107B
7.INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY (for Automatic Air Conditioning System)
Install the radiator unit to the rear cooling unit.
Install the heater clamp with the screw and attach the claw.
8.INSTALL BRACKET (for Automatic Air Conditioning System)
Install the bracket with the 3 screws.
87452Q
9.INSTALL NO. 1 HEATER BRACKET
Install the No. 1 heater bracket with the screw.
87255C
10.INSTALL REAR HEATER WATER INLET HOSE C (for Automatic Air Conditioning System)
Install the heater inlet hose with the clip.
87256C
11.INSTALL REAR HEATER WATER OUTLET HOSE C (for Automatic Air Conditioning System)
Install the heater outlet hose with the clip.
87248C
12.INSTALL HEATER WATER INLET PIPE C (for Automatic Air Conditioning System)
Install the water inlet pipe with the clip.
87249C
13.INSTALL HEATER WATER OUTLET PIPE C (for Automatic Air Conditioning System)
Install the water outlet pipe with the clip.
Install the screw and clamp.
Install the heater cover with the 3 screws.
88717A
14.INSTALL COOLER REFRIGERANT SUCTION PIPE A
Sufficiently apply compressor oil to new O-ring and the fitting surface of the hose joint.
ND-OIL 8 or equivalent
Install the O-ring to the suction pipe.
Install the suction pipe.
88716C
15.INSTALL COOLER REFRIGERANT LIQUID PIPE C
Sufficiently apply compressor oil to new O-ring and the fitting surface of the hose joint.
ND-OIL 8 or equivalent
Install the O-ring to the liquid pipe.
Install the liquid pipe with the 2 screws and clamp.
Install the heater cover with the 3 screws.
Install the plate with the bolt.
Install the new packing.
87106J
16.INSTALL MODE DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)
Install the damper servo with the 2 screws.
Connect the connector.
87106W
17.INSTALL AIR MIX REAR DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)
Install the damper servo with the 2 screws.
Connect the connector.
88539K
18.INSTALL DRAIN COOLER HOSE
Install the drain hose to the rear cooling unit.