Home › Vehicle Interior › AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM24M0E _58 Vehicle Interior _059584 AIR CONDITIONING _0292180 AIR CONDITIONING SYSTEM C

AIR CONDITIONING  AIR CONDITIONING SYSTEM  B1443/43  Air Outlet Damper Control Servo Motor Circuit  


DESCRIPTION

The damper servo sends pulse signals to indicate the damper position to the air conditioning amplifier. The air conditioning amplifier activates the motor (normal or reverse) based on these signals to move the mode damper to the appropriate position, which controls the air outlet modes.

HINT:

Confirm that there are no mechanical problems because this DTC can be output when either a damper link or damper is mechanically locked.

DTC No. DTC Detection Condition Trouble Area
B1443/43 Air outlet damper position does not change even if air conditioning amplifier operates air outlet damper control servo motor
·

Air outlet control servo motor

·

Air conditioning harness

·

Air conditioning amplifier




WIRING DIAGRAM

E133419E21
3.188,2.813 4.76,3.125 1.573,0.313 10 false Air Conditioning Harness 0.76,2.844 2.698,3.198 1.938,0.354 10 false Air Outlet Control Servo Motor 5.115,2.823 5.531,3.052 0.417,0.229 10 false a1 5.229,0.969 5.781,1.135 0.552,0.167 10 false B BUS 5.24,1.594 5.563,1.76 0.323,0.167 10 false BUS 5.229,2.229 5.875,2.396 0.646,0.167 10 false BUS G 5.01,0.813 5.208,1.01 0.198,0.198 10 false 4 4.99,1.458 5.188,1.656 0.198,0.198 10 false 3 4.99,2.104 5.188,2.302 0.198,0.198 10 false 2 5.115,3 6.719,3.385 1.604,0.385 10 false Air Conditioning Amplifier

PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (AIR OUT PULSE)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch on (IG) and turn the intelligent tester main switch ON.


c.

Select the items below in the Data List, and read the value displayed on the intelligent tester.

Air conditioning amplifier:
Item Measurement Item / Display (Range) Normal Condition Diagnostic Note
Air Out Pulse Air outlet servo motor target pulse /
Min.: 0, Max.: 255
Customized value displayed -


OK:

The display is as specified in the normal condition column.


Result
Result Proceed to
NG A
OK (Checking from PROBLEM SYMPTOMS TABLE) B
OK (Checking from DTC) C



A

2.REPLACE AIR OUTLET CONTROL SERVO MOTOR

B

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

C

REPLACE AIR CONDITIONING AMPLIFIER

2.REPLACE AIR OUTLET CONTROL SERVO MOTOR
HINT:

Since the servo motor cannot be tested when it is removed from the vehicle, replace the servo motor with a normal one and check that the condition returns to normal.


OK:

Same problem does not occur.



OK

SYSTEM IS OK

NG

REPAIR OR REPLACE AIR CONDITIONING HARNESS