Home › Vehicle Interior › AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM24M0E _58 Vehicle Interior _059584 AIR CONDITIONING _0292180 AIR CONDITIONING SYSTEM C

AIR CONDITIONING  AIR CONDITIONING SYSTEM  B1446/46  Air Mix Damper Control Servo Motor Circuit (Driver Side)  


DESCRIPTION

The air mix damper servo sends pulse signals to indicate the damper position to the air conditioning amplifier. The air conditioning amplifier activates the motor (normal or reverse) based on these signals to move the air mix damper (driver seat) to the appropriate position. This adjusts the amount of air passing through the heater core after passing the evaporator and controls the temperature of the blown air.

HINT:

Confirm that there are no mechanical problems because this DTC can be output when either a damper link or damper is mechanically locked.


DTC No. DTC Detection Condition Trouble Area
B1446/46 Air mix damper position does not change even if air conditioning amplifier operates air mix damper control servo motor
·

Air mix control servo motor

·

Air conditioning harness

·

Air conditioning amplifier



WIRING DIAGRAM

E133419E20
3.188,2.813 4.76,3.125 1.573,0.313 10 false Air Conditioning Harness 0.823,2.844 2.542,3.24 1.719,0.396 10 false Air Mix Control Servo Motor (for Driver Side) 5.115,2.823 5.531,3.052 0.417,0.229 10 false a1 5.229,0.969 5.781,1.135 0.552,0.167 10 false B BUS 5.24,1.594 5.563,1.76 0.323,0.167 10 false BUS 5.229,2.229 5.875,2.396 0.646,0.167 10 false BUS G 5.01,0.813 5.208,1.01 0.198,0.198 10 false 4 4.99,1.458 5.188,1.656 0.198,0.198 10 false 3 4.99,2.104 5.188,2.302 0.198,0.198 10 false 2 5.115,3 6.719,3.385 1.604,0.385 10 false Air Conditioning Amplifier

PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (AIR MIX SERVO TARG PULSE (D))
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch on (IG) and turn the intelligent tester main switch ON.


c.

Select the items below in the Data List, and read the value displayed on the intelligent tester.

Air conditioning amplifier:
Item Measurement Item / Display (Range) Normal Condition Diagnostic Note
Air Mix Pulse-D Driver side air mix servo motor target pulse /
Min.: 0, Max.: 255
Customized value displayed -


OK:

The display is as specified in the normal condition column.


Result
Result Proceed to
NG A
OK (Checking from PROBLEM SYMPTOMS TABLE) B
OK (Checking from DTC) C



A

2.REPLACE AIR MIX CONTROL SERVO MOTOR

B

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

C

REPLACE AIR CONDITIONING AMPLIFIER

2.REPLACE AIR MIX CONTROL SERVO MOTOR
HINT:

Since the servo motor cannot be tested when it is removed from the vehicle, replace the servo motor with a normal one and check that the condition returns to normal.


OK:

Same problem does not occur.



OK

SYSTEM IS OK

NG

REPAIR OR REPLACE AIR CONDITIONING HARNESS