Home › Vehicle Interior › AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM24M0E _58 Vehicle Interior _059584 AIR CONDITIONING _0292180 AIR CONDITIONING SYSTEM C

AIR CONDITIONING  AIR CONDITIONING SYSTEM  B1451/51  Compressor Solenoid Circuit  


DESCRIPTION

In this circuit, the compressor receives a refrigerant compression demand signal from the air conditioning amplifier.

Based on this signal, the compressor changes the degree of refrigerant compression.

DTC No. DTC Detection Condition Trouble Area
B1451/51 Open or short in solenoid of externally changeable compressor circuit
·

Compressor and pulley

·

Wire harness between air conditioning amplifier and compressor and pulley

·

Air conditioning amplifier



WIRING DIAGRAM

E115016E40
0.802,2.219 1.146,2.375 0.344,0.156 10 false E11 0.792,2.375 2.302,2.729 1.51,0.354 10 false Compressor and Pulley 4.938,2.208 5.323,2.365 0.385,0.156 10 false L76 4.927,2.365 6.521,2.729 1.594,0.365 10 false Air Conditioning Amplifier 1.604,0.896 2.01,1.052 0.406,0.156 10 false SOL+ 5.167,0.896 5.573,1.052 0.406,0.156 10 false SOL+ 1.635,1.698 2.042,1.854 0.406,0.156 10 false SOL- 2.146,0.771 2.344,0.927 0.198,0.156 10 false 2 2.167,1.573 2.365,1.729 0.198,0.156 10 false 1 4.906,0.781 5.104,0.938 0.198,0.156 10 false 4

PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (REG CTRL CURRNT)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch on (IG) and turn the intelligent tester main switch ON.


c.

Select the items below in the Data List, and read the value displayed on the intelligent tester.

Air conditioning amplifier:
Item Measurement Item / Display (Range) Normal Condition Diagnostic Note
Reg Ctrl Currnt Regulator control current /
Min.: 0 A
Max.: 0.997 A
Value changes between 0 A and 0.997 A in accordance with compressor and magnetic clutch operation -


OK:

The display is as specified in the normal condition column.


Result
Result Proceed to
NG A
OK (Checking from PROBLEM SYMPTOMS TABLE) B
OK (Checking from DTC) C



A

2.INSPECT COMPRESSOR AND PULLEY

B

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

C

REPLACE AIR CONDITIONING AMPLIFIER

2.INSPECT COMPRESSOR AND PULLEY
E115015E09
0.241,0.103 2.706,0.451 2.465,0.348 10 Component without harness connected: (Compressor and Pulley)

a.

Disconnect the compressor and pulley connector.


b.

Measure the resistance of the connector.

Standard resistance:
Tester Connection Condition Specified Condition
1 - 2 25°C (77°F) 10.1 to 11.1 Ω




OK

3.CHECK WIRE HARNESS (COMPRESSOR AND PULLEY - AIR CONDITIONING AMPLIFIER)

NG

REPLACE COMPRESSOR AND PULLEY

3.CHECK WIRE HARNESS (COMPRESSOR AND PULLEY - AIR CONDITIONING AMPLIFIER)
E358385E01
0.583,1.417 1,1.667 0.417,0.25 1.667,2.667 2.083,2.917 0.417,0.25 2.771,4.271 2.542,3.958 true 0.083,0.063 1.76,0.344 1.677,0.281 10 false Wire Harness Side: 1.073,0.552 2.802,0.885 1.729,0.333 10 false Compressor and Pulley 0.656,1.448 1.094,1.667 0.438,0.219 10 false D40 1.729,2.708 2.167,2.927 0.438,0.219 10 false G47 1.135,2.292 2.948,2.656 1.813,0.365 10 false Air Conditioning Amplifier 2.75,4.292 3.188,4.51 0.438,0.219 10 false SOL+

a.

Disconnect the D40 compressor and pulley connector.


b.

Disconnect the G47 amplifier connector.


c.

Measure the resistance of the wire harness side connectors.

Standard resistance:
Tester Connection Specified Condition
D40-2 - G47-2 (SOL+) Below 1 Ω
D40-2 - Body Ground 1 MΩ or higher




OK

4.CHECK WIRE HARNESS (COMPRESSOR AND PULLEY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK WIRE HARNESS (COMPRESSOR AND PULLEY - BODY GROUND)
U131734E02
1.479,1.844 1.042,2.51 false 0.354,0.219 2.667,0.615 2.313,0.396 10 false Front view of wire harness connector: (to Compressor and Pulley) 0.438,1.49 0.833,1.698 0.396,0.208 10 false E11 0.75,2.542 1.156,2.719 0.406,0.177 10 false SOL-

a.

Disconnect the D40 compressor and pulley connector.


b.

Measure the resistance of the wire harness side connector.

Standard resistance:
Tester Connection Specified Condition
D40-1 - Body Ground Below 1 Ω




OK

REPLACE AIR CONDITIONING AMPLIFIER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR