Home › Vehicle Interior › AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM24M0E _58 Vehicle Interior _059584 AIR CONDITIONING _0292180 AIR CONDITIONING SYSTEM J

AIR CONDITIONING  AIR CONDITIONING SYSTEM  Back-up Power Source Circuit  


DESCRIPTION

This is the back-up power source circuit for the air conditioning amplifier. Power is supplied even when the ignition switch is turned off and is used for functions such as the diagnostic trouble code memory.

WIRING DIAGRAM

E127573E03
5.125,1.052 5.406,1.229 0.281,0.177 10 false G47 5.115,1.479 5.396,1.656 0.281,0.177 10 false G48 5.125,2.146 5.406,2.323 0.281,0.177 10 false G47 5.115,2.542 5.396,2.719 0.281,0.177 10 false G48 5.177,1.969 5.344,2.146 0.167,0.177 10 false 14 5.188,2.375 5.354,2.552 0.167,0.177 10 false 20 1.188,1.854 1.75,2.031 0.563,0.177 10 false FL MAIN 1.313,2.729 1.771,2.906 0.458,0.177 10 false Battery 3.333,1.219 3.781,1.396 0.448,0.177 10 false ECU-B 1.948,1.25 2.573,1.427 0.625,0.177 10 false F/B BATT 5.24,3.198 6.813,3.375 1.573,0.177 10 false Air Conditioning Amplifier 5.51,1.052 5.667,1.229 0.156,0.177 10 false B 5.521,1.479 5.844,1.656 0.323,0.177 10 false +B2* 5.51,2.167 5.833,2.344 0.323,0.177 10 false GND 5.51,2.573 5.969,2.75 0.458,0.177 10 false GND2* 0.094,3.521 1.667,3.698 1.573,0.177 10 false *: w/ Rear Automatic A/C 5.188,0.875 5.354,1.052 0.167,0.177 10 false 21 5.188,1.302 5.354,1.479 0.167,0.177 10 false 24

PROCEDURE

1.INSPECT FUSE (ECU-B)
a.

Remove the ECU-B fuse from the engine room No. 1 relay block.


b.

Measure the resistance of the fuse.

Standard resistance:

Below 1 Ω




OK

2.CHECK WIRE HARNESS (AIR CONDITIONING AMPLIFIER - BATTERY)

NG

REPLACE FUSE

2.CHECK WIRE HARNESS (AIR CONDITIONING AMPLIFIER - BATTERY)
U189859E02
2.615,2.24 2.938,2.708 false 0.281,2.26 0.667,2.802 false 0.49,1.073 0.771,1.25 0.281,0.177 10 false G48 0.094,0.021 1.375,0.208 1.281,0.188 10 false Wire Harness Side: 0.156,3.135 1.708,3.313 1.552,0.177 10 false *: w/ Rear Automatic A/C 0.917,0.521 2.49,0.698 1.573,0.177 10 false Air Conditioning Amplifier 2.948,2.677 3.104,2.854 0.156,0.177 10 false B 1.781,1.104 2.063,1.281 0.281,0.177 10 false G47 0.719,2.74 1.073,2.917 0.354,0.177 10 false +B2*

a.

Disconnect the G47 and G48 amplifier connectors.


b.

Measure the voltage of the wire harness side connectors.

Standard voltage:
Tester Connection Specified Condition
G47-21 (B) - Body ground 10 to 14 V
G48-24 (+B2)* - Body ground 10 to 14 V


HINT:

*: w/ Rear automatic A/C




OK

3.CHECK WIRE HARNESS (AIR CONDITIONING AMPLIFIER - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK WIRE HARNESS (AIR CONDITIONING AMPLIFIER - BODY GROUND)
U189858E02
1.698,2.156 2.115,2.719 true 0.563,2.25 0.948,2.802 true 0.49,1.052 0.771,1.229 0.281,0.177 10 false G48 0.094,0.031 1.375,0.219 1.281,0.188 10 false Wire Harness Side: 0.135,3.146 1.833,3.385 1.698,0.24 10 false *: w/ Rear Automatic A/C 0.917,0.521 2.49,0.698 1.573,0.177 10 false Air Conditioning Amplifier 2.146,2.708 2.469,2.885 0.323,0.177 10 false GND 1.792,1.094 2.073,1.271 0.281,0.177 10 false G47 1.01,2.771 1.469,2.948 0.458,0.177 10 false GND2*

a.

Disconnect the G47 and G48 amplifier connectors.


b.

Measure the resistance of the wire harness side connectors.

Standard resistance:
Tester Connection Specified Condition
G47-14 (GND) - Body ground Below 1 Ω
G48-20 (GND2)* - Body ground Below 1 Ω


HINT:

*: w/ Rear automatic A/C




OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR