This circuit consists of the rear air conditioning control and the air conditioning amplifier. When the rear air conditioning control is operated, signals are transmitted to the air conditioning amplifier through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier does not operate even if the rear air conditioning control is operated.
Disconnect the Q11 rear air conditioning control connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
|---|---|
| Q11-12 (E) - Body ground | Below 1 Ω |
OK
NG
Disconnect the Q11 rear air conditioning control connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Q11-12 (E) - Q11-7 (IG+) | Ignition switch on (IG) | 10 to 14 V |
OK
NG
Disconnect the Q11 control connector.
Disconnect the G48 amplifier connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
|---|---|
| G48-13 (BLIN) - Q11-5 (MPX-) | Below 1 Ω |
| G48-13 (BLIN) - Body ground | 10 kΩ or higher |
OK
NG
Replace the rear air conditioning control with a new or properly functioning one.
Operate the rear air conditioning control to check that it functions properly.
Rear air conditioning control function operates normally.
| Result | Proceed to |
|---|---|
| Rear air conditioning control malfunctions | A |
| Rear air conditioning control functions properly | B |
A
B