This circuit consists of the air conditioning control and the air conditioning amplifier. When the air conditioning control is operated, signals are transmitted to the air conditioning amplifier through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier does not operate even if the air conditioning control is operated.
Disconnect the G37 air conditioning control connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
|---|---|
| G37-6 (GND) - Body ground | Below 1 Ω |
OK
NG
Disconnect the G37 air conditioning control connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G37-6 (GND) - G37-1 (IG+) | Ignition switch on (IG) | 10 to 14 V |
OK
NG
Disconnect the G37 control connector.
Disconnect the G47 amplifier connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
|---|---|
| G47-37 (LIN1) - G37-3 (LIN1) | Below 1 Ω |
| G47-37 (LIN1) - Body ground | 10 kΩ or higher |
OK
NG
Replace the air conditioning control with a new or properly functioning one.
Operate the air conditioning control to check that it functions properly.
Air conditioning control function operates normally.
| Result | Proceed to |
|---|---|
| Air conditioning control malfunctions | A |
| Air conditioning control functions properly | B |
A
B