Home › Vehicle Interior › AIR CONDITIONING › AIR CONDITIONING SYSTEM › from 2016.05
RM24M0E _58 Vehicle Interior _059584 AIR CONDITIONING _0292180 AIR CONDITIONING SYSTEM C

AIR CONDITIONING  AIR CONDITIONING SYSTEM  B14B9  Open in Ion Generator Circuit  


DESCRIPTION

The No. 2 ion generator sub-assembly operates when the blower switch on. The air conditioning amplifier sends a drive signal to the No. 2 ion generator sub-assembly. When the No. 2 ion generator sub-assembly receives the drive signal and starts to operate, it outputs an operation condition signal to the air conditioning amplifier.

DTC No. DTC Detection Condition Trouble Area
B14B9 Open in No. 2 ion generator sub-assembly circuit
·

No. 2 ion generator sub-assembly

·

Harness or connector between No. 2 ion generator sub-assembly and air conditioning amplifier

·

Harness or connector between No. 2 ion generator sub-assembly and IG power source

·

Harness or connector between No. 2 ion generator sub-assembly and body ground

·

Air conditioning amplifier



WIRING DIAGRAM

E233623E09
2.513,2.82 5.253,2.968 2.740,0.148 10 No. 2 Ion Generator Sub-assembly 2.513,2.664 2.883,2.812 0.369,0.148 10 n2 5.789,0.694 6.175,0.842 0.386,0.148 10 NAIN 5.789,2.03 6.212,2.178 0.423,0.148 10 NANO 5.487,0.511 5.664,0.659 0.177,0.148 10 15 5.501,1.817 5.678,1.965 0.177,0.148 10 11 2.693,0.694 2.866,0.842 0.173,0.148 10 IG 1.687,0.85 2.459,0.998 0.772,0.148 10 RH ECU-IG 3.641,0.694 3.889,0.842 0.248,0.148 10 IG+ 3.597,2.03 3.889,2.178 0.292,0.148 10 PCL 2.693,2.03 3.043,2.178 0.350,0.148 10 GND 2.547,0.606 2.659,0.754 0.112,0.148 10 1 3.944,1.947 4.051,2.094 0.107,0.148 10 2 3.95,0.606 4.051,0.754 0.101,0.148 10 3 2.547,1.947 2.646,2.094 0.099,0.148 10 4 0.37,0.639 1.099,0.964 0.729,0.326 10 from RH-IG Relay1 5.722,2.677 6.743,3.009 1.021,0.332 10 Air Conditioning Amplifier 5.436,0.692 5.759,0.840 0.322,0.148 10 G47 5.444,2.02 5.766,2.168 0.322,0.148 10 G48

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
a.

Connector the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Active Test.


e.

Check the operation by referring to the table below.

Air Conditioner
Tester Display Test Part Control Range Diagnostic Note
Ion Generator No. 2 ion generator sub-assembly OFF, ON -

OK:

No. 2 ion generator sub-assembly operates normally.


Result:
Result Proceed to
NG A
OK (When troubleshooting according to Problem Symptoms Table) B
OK (When troubleshooting according to the DTC) C




A

2.CHECK HARNESS AND CONNECTOR (NO. 2 ION GENERATOR SUB-ASSEMBLY - BODY GROUND)

B

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

C

REPLACE AIR CONDITIONING AMPLIFIER

2.CHECK HARNESS AND CONNECTOR (NO. 2 ION GENERATOR SUB-ASSEMBLY - BODY GROUND)
a.

Disconnect the n2 No. 2 ion generator sub-assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
n2-4 (GND) - Body ground Always Below 1 Ω




OK

3.CHECK HARNESS AND CONNECTOR (NO. 2 ION GENERATOR SUB-ASSEMBLY - IG POWER SOURCE)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK HARNESS AND CONNECTOR (NO. 2 ION GENERATOR SUB-ASSEMBLY - IG POWER SOURCE)
a.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
n2-1 (IG) - Body ground Engine switch off Below 1 V
n2-1 (IG) - Body ground Engine switch on (IG) 11 to 14 V




OK

4.CHECK HARNESS AND CONNECTOR (NO. 2 ION GENERATOR SUB-ASSEMBLY - AIR CONDITIONING AMPLIFIER)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK HARNESS AND CONNECTOR (NO. 2 ION GENERATOR SUB-ASSEMBLY - AIR CONDITIONING AMPLIFIER)
a.

Disconnect the G47 and G48 air conditioning amplifier connectors.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G47-15 (NAIN) - n2-3 (IG+) Always Below 1 Ω
G48-11 (NANO) - n2-2 (PCL) Always Below 1 Ω
G47-15 (NAIN) or n2-3 (IG+) - Body ground Always 10 kΩ or higher
G48-11 (NANO) or n2-2 (PCL) - Body ground Always 10 kΩ or higher




OK

5.REPLACE NO. 2 ION GENERATOR SUB-ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.REPLACE NO. 2 ION GENERATOR SUB-ASSEMBLY
a.

Replace the No. 2 ion generator sub-assembly (See page Vehicle Interior>AIR CONDITIONING>ION GENERATOR>REMOVAL).

HINT:

Since the No. 2 ion generator sub-assembly cannot be inspected while it is removed from the vehicle, replace the No. 2 ion generator sub-assembly with a new or known good one and check that the condition returns to normal.



b.

Check for the DTC.

Result:
Result Proceed to
DTC B14B9 is not output A
DTC B14B9 is output B




A

END (NO. 2 ION GENERATOR SUB-ASSEMBLY WAS DEFECTIVE)

B

REPLACE AIR CONDITIONING AMPLIFIER