Home › Vehicle Interior › AIR CONDITIONING › COMPRESSOR(for 2GR-FE)
RM24M0E _58 Vehicle Interior _059584 AIR CONDITIONING _0292185 COMPRESSOR(for 2GR-FE) G

AIR CONDITIONING  COMPRESSOR(for 2GR-FE)  INSPECTION  


PROCEDURE

Hide 88320 1.INSPECT COMPRESSOR AND MAGNETIC CLUTCH (A/C LOCK SENSOR)

a.
E005280

Measure the resistance according to the value(s) in the table below.

Standard resistance:
Tester Connection Condition Specified Condition
1 - 2 Always
(at 20°C (68°F))
160 to 320 Ω


If the resistance is not as specified, replace the compressor and magnetic clutch.


Hide 88320 2.INSPECT COMPRESSOR AND MAGNETIC CLUTCH (A/C COMPRESSOR SOLENOID)

a.
E116970E04
0.094,0.065 2.115,0.397 2.021,0.332 10 Compressor and Magnetic Clutch Connector Front View:

Measure the resistance according to the value(s) in the table below.

Standard resistance:
Tester Connection Condition Specified Condition
2 - 1 20°C (68°F) 10 to 11 Ω


If the resistance is not as specified, replace the compressor and magnetic clutch.


Hide 88320 3.INSPECT COMPRESSOR AND MAGNETIC CLUTCH

a.
U189795E02
0.063,0.073 2.74,0.292 2.677,0.219 10 false A/C Compressor Connector Front View: 0.771,1.042 1.021,1.292 0.25,0.25 10 false A

Disconnect the connector from the compressor and magnetic clutch.


b.
U189821E01
0.065,0 1.622,0.334 1.557,0.334 10 Magnetic Clutch Connector Front View: 0.884,1.34 1.026,1.496 0.142,0.156 10 B

Disconnect the connector from the magnetic clutch.


c.

Measure the resistance according to the value(s) in the table below.

Standard resistance:
Tester Connection Condition Specified Condition
A-3 - B-1 Always Below 1 Ω
A-3 - Body ground Always 10 kΩ or higher


If the resistance is not as specified, replace the compressor and magnetic clutch.


Hide 88410 4.INSPECT MAGNETIC CLUTCH

a.
E113611E02
0.092,0 0.873,0.702 0.781,0.702 10 Magnetic Clutch Connector Front View:

Measure the resistance according to the value(s) in the table below.

Standard resistance:
Tester Connection Condition Specified Condition
1 - Body ground 20 °C (68°F) 3.8 to 4.2 Ω


If the resistance is not as specified, replace the magnetic clutch.


b.

When connector terminal 1 is connected to the positive (+) battery terminal, check that the following occurs: 1) the magnetic clutch's operating sound can be heard, and 2) the magnetic clutch's hub and rotor lock.

OK:
1):

The magnetic clutch's operating sound can be heard.

2):

The magnetic clutch's hub and rotor lock.


If the result is not as specified, replace the magnetic clutch.