CHECK COMBINATION METER ASSEMBLY (METER ECU)
Disconnect the G28 meter connector.
Measure the voltage and resistance of the wire harness side connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| IG2 (G28-21) - Body ground | G - Body ground | Ignition power supply | Ignition switch off | Below 1 V |
| IG2 (G28-21) - Body ground | G - Body ground | Ignition power supply | Ignition switch on (IG) | 10 to 14 V |
| B (G28-22) - Body ground | W - Body ground | Battery power supply | Always | 10 to 14 V |
| FE (G28-30) - Body ground | BE - Body ground | Ground (fuel gauge ground) | Always | 10 kΩ or higher |
| EP (G28-33) - Body ground | BR - Body ground | Ground (meter ground) | Always | Below 1 Ω |
If the result is not as specified, there may be a malfunction on the wire harness side.
Reconnect the G28 meter connector.
Measure the voltage of the connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| PBLT (G28-6)*1 - Body ground | SB - Body ground | Front passenger seat belt condition output signal | Front passenger seat belt warning light is OFF | 10 to 14 V |
| PBLT (G28-6)*1 - Body ground | SB - Body ground | Front passenger seat belt condition output signal | Front passenger seat belt warning light blinking | Below 1 V ←→ 10 to 14 V |
| P/SB (G28-29)*1 - Body ground | G - Body ground | Front passenger seat belt condition input signal | Front passenger seat belt warning light is OFF | 10 to 14 V |
| P/SB (G28-29)*1 - Body ground | G - Body ground | Front passenger seat belt condition input signal | Front passenger seat belt warning light blinking | Below 1 V |
| B (G28-23) - Body ground | Y - Body ground | Turn signal RH signal | Ignition switch on (IG), turn RH indicator light OFF | Below 1 V |
| B (G28-23) - Body ground | Y - Body ground | Turn signal RH signal | Ignition switch on (IG), turn RH indicator light ON | Below 1 V ←→ 10 to 14 V |
| B (G28-24) - Body ground | Y - Body ground | Turn signal LH signal | Ignition switch on (IG), turn LH indicator light OFF | Below 1 V |
| B (G28-24) - Body ground | Y - Body ground | Turn signal LH signal | Ignition switch on (IG), turn LH indicator light ON | Below 1 V ←→ 10 to 14 V |
| LP (G28-4) - Body ground | V - Body ground | Security indicator signal | Security indicator light OFF | Below 1 V |
| LP (G28-4) - Body ground | V - Body ground | Security indicator signal | Security indicator light blinking | Below 1 V ←→ 10 to 14 V |
| S (G28-38) - Body ground | GR - Body ground | Engine oil pressure warning signal | Ignition switch on (IG), engine oil pressure warning light ON | Below 1 V |
| S (G28-38) - Body ground | GR - Body ground | Engine oil pressure warning signal | Ignition switch on (IG), engine oil pressure warning light OFF | 10 to 14 V |
| EFI (G28-25) - Body ground | Y - Body ground | MIL signal | MIL ON | Below 1 V |
| EFI (G28-25) - Body ground | Y - Body ground | MIL signal | MIL OFF | 10 to 14 V |
| CHG- (G28-13) - Body ground | LG - Body ground | Generator signal | Charge warning light ON | Below 1 V |
| CHG- (G28-13) - Body ground | LG - Body ground | Generator signal | Charge warning light OFF | 10 to 14 V |
| #10 (G28-26) - Body ground | L - Body ground | Brake fluid level signal | Brake fluid level warning light ON | 10 to 14 V |
| #10 (G28-26) - Body ground | L - Body ground | Brake fluid level signal | Brake fluid level warning light OFF | Below 1 V |
| L (G28-27) - Body ground | L - Body ground | Fuel level signal | Ignition switch on (IG), fuel level is FULL | Below 1 V |
| L (G28-27) - Body ground | L - Body ground | Fuel level signal | Ignition switch on (IG), fuel level is EMPTY | 4.5 to 9 V |
| TC O (G28-35) - Body ground | P - Body ground | Rheostat switch signal | Ignition switch on (IG), rheostat switch OFF | 4.5 to 5.5 V |
| TC O (G28-35) - Body ground | P - Body ground | Rheostat switch signal | Ignition switch on (IG), rheostat switch ON | Below 1 V |
| CANL (G28-31) - Body ground | W - Body ground | CAN communication line | Ignition switch on (IG) | Pulse generation |
| CANH (G28-32) - Body ground | B - Body ground | CAN communication line | Ignition switch on (IG) | Pulse generation |
| MPX+ (G28-18) - Body ground | LG - Body ground | CAN communication line | Ignition switch on (IG) | Pulse generation |
| MPX- (G28-19) - Body ground | W - Body ground | CAN communication line | Ignition switch on (IG) | Pulse generation |
| SI (G28-39) - Body ground | V - Body ground | Speed signal (input) | Ignition switch on (IG), slowly turn wheel | Pulse generation |
| +S (G28-40) - Body ground | W - Body ground | Speed signal (output) | Ignition switch on (IG), slowly turn wheel | Pulse generation |
| FLDS (G28-16) - Body ground | W - Body ground | Fold seat signal | Fold seat light ON | Below 1 V |
| FLDS (G28-16) - Body ground | W - Body ground | Fold seat signal | Fold seat light OFF | 10 to 14 V |
| ODO (G28-34) - Body ground | V - Body ground | ODO/TRIP switch signal | ODO/TRIP switch pressed | Below 1 V |
| ODO (G28-34) - Body ground | V - Body ground | ODO/TRIP switch signal | ODO/TRIP switch not pressed | 4 to 6 V |
| RSET (G28-8) - Body ground | W - Body ground | Clock "00" switch signal | Clock "00" switch pressed | Below 1 V |
| RSET (G28-8) - Body ground | W - Body ground | Clock "00" switch signal | Clock "00" switch not pressed | 4 to 6 V |
| M (G28-9) - Body ground | R - Body ground | Clock "M" switch signal | Clock "M" switch pressed | Below 1 V |
| M (G28-9) - Body ground | R - Body ground | Clock "M" switch signal | Clock "M" switch not pressed | 4 to 6 V |
| H (G28-10) - Body ground | L - Body ground | Clock "H" switch signal | Clock "H" switch pressed | Below 1 V |
| H (G28-10) - Body ground | L - Body ground | Clock "H" switch signal | Clock "H" switch not pressed | 4 to 6 V |
*1: for RHD
If the result is not as specified, the combination meter may be malfunctioning.
| Terminal No. | Wire Harness Side | |
|---|---|---|
| G28 | 1 | - |
| 2 | - | |
| 3 | - | |
| 4 | Security | |
| 5 | - | |
| 6 | Front passenger Seat Belt Warning Light | |
| 7 | - | |
| 8 | Clock (Set) | |
| 9 | Clock (Minute) | |
| 10 | Clock (Hour) | |
| 11 | - | |
| 12 | - | |
| 13 | Generator | |
| 14 | - | |
| 15 | - | |
| 16 | 3rd seat | |
| 17 | - | |
| 18 | CAN (Middle Speed) | |
| 19 | CAN (Middle Speed) | |
| 20 | - | |
| 21 | Ignition Switch | |
| 22 | Battery | |
| 23 | Turn Signal Flasher (R) | |
| 24 | Turn Signal Flasher (L) | |
| 25 | MIL | |
| 26 | Brake Fluid Level Warning Switch | |
| 27 | Fuel Sender Gauge | |
| 28 | - | |
| 29 | Front passenger Seat Belt Warning Light | |
| 30 | Fuel Sender Gauge (GND) | |
| 31 | CAN-Lo (Low Speed) | |
| 32 | CAN-Hi (High Speed) | |
| 33 | GND | |
| 34 | ODO/TRIP | |
| 35 | Rheostat | |
| 36 | - | |
| 37 | - | |
| 38 | Engine Oil Pressure Warning Switch | |
| 39 | Skid Control ECU | |
| 40 | Each part that uses the speed signal | |