Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2013.04–2016.05
RM24M0E _58 Vehicle Interior _059587 METER / GAUGE / DISPLAY _0292197 METER / GAUGE SYSTEM C

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  U0100  Lost Communication with ECM / PCM "A"  


DESCRIPTION

The combination meter assembly and the ECM exchange signals through the CAN communication system.

DTC No. DTC Detection Conditions Trouble Areas
U0100 When either of following conditions detected:
1.

Vehicle speed 5 km/h or more and IG voltage 10.5 V or more

2.

No communication with ECM continues for 3 seconds or more (No communication to ECM or skid control ECU continues for 60 seconds or more)


·

CAN communication system

·

ECM



WIRING DIAGRAM

E358399E01
1.896,1.073 2.448,1.281 0.552,0.208 10 false CANH 1.906,1.719 2.458,1.927 0.552,0.208 10 false CANL 2.427,1.188 2.979,1.396 0.552,0.208 10 false 41 2.438,1.854 2.99,2.063 0.552,0.208 10 false 49 3.26,1.188 4.052,1.406 0.792,0.219 10 false CAN Line 4.615,1.177 5.167,1.385 0.552,0.208 10 false 32 4.615,1.844 5.167,2.052 0.552,0.208 10 false 31 5.135,2.542 5.688,2.75 0.552,0.208 10 false G28 5.135,2.719 6.635,3.021 1.5,0.302 10 false Combination Meter 1.115,2.531 1.667,2.74 0.552,0.208 10 false A7 1.104,2.708 1.656,2.917 0.552,0.208 10 false ECM 4.927,1.063 5.479,1.271 0.552,0.208 10 false CANH 4.927,1.729 5.479,1.938 0.552,0.208 10 false CANL 3.302,1.844 4.094,2.063 0.792,0.219 10 false CAN Line

PROCEDURE

1.CONFIRM DTC OUTPUT
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch on (IG) and turn the tester ON.


c.

Clear the stored DTCs by selecting the following menu items on the tester: Body / Combination Meter / DTC / Clear.


d.

Drive the vehicle at more than 5 km/h for at least 60 seconds.


e.

Stop the vehicle.


f.

Check for DTCs.

Result
Result Proceed to
DTC output A
DTC not output B



A

GO TO CAN COMMUNICATION SYSTEM

B

SYSTEM IS OK