Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › from 2016.05
RM24M0E _58 Vehicle Interior _059587 METER / GAUGE / DISPLAY _0292197 METER / GAUGE SYSTEM C

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0129  Lost Communication with Brake System Control Module  U0131  Lost Communication with Power Steering Control Module  U0151  Lost Communication with Restraints Control Module  


DESCRIPTION

The combination meter sub-assembly communicates with the ECM, brake actuator assembly (skid control ECU), power steering ECU assembly and center airbag sensor assembly via CAN communication.

DTC No. DTC Detection Condition Trouble Area Note
U0100
w/o Multi-information Display:

When either of the following conditions is detected:

(a)

Vehicle speed is 5 km/h (3.1 mph) or more and IG voltage is 10.5 V or more

(b)

No communication with ECM continues for 3 seconds or more (No communication to ECM or brake actuator assembly (skid control ECU) continues for 60 seconds or more)



w/ Multi-information Display:

When either of the following conditions is detected:

(a)

IG voltage is 9.5 V or more

(b)

No communication with ECM continues for 2 seconds or more



·

ECM

·

CAN communication system

·

Combination meter sub-assembly


-
U0129
w/o Multi-information Display:

When either of the following conditions is detected:

(a)

Vehicle speed is 5 km/h (3.1 mph) or more and IG voltage is 10.5 V or more

(b)

No communication with brake actuator assembly (skid control ECU) continues for 3 seconds or more (No communication to ECM or brake actuator assembly (skid control ECU) continues for 60 seconds or more)



w/ Multi-information Display:

When either of the following conditions is detected:

(a)

IG voltage is 9.5 V or more

(b)

No communication with brake actuator assembly (skid control ECU) continues for 2 seconds or more



·

Brake actuator assembly (skid control ECU)

·

CAN communication system

·

Combination meter sub-assembly


-
U0131 When either of the following conditions is detected:
1.

IG voltage is 9.5 V or more

2.

No communication with power steering ECU assembly continues for 3 seconds or more


·

Power steering ECU assembly

·

CAN communication system

·

Combination meter sub-assembly


w/ Multi-information Display
U0151 When either of the following conditions is detected:
1.

IG voltage is 9.5 V or more

2.

No communication with center airbag sensor assembly continues for 10 seconds or more


·

Center airbag sensor assembly

·

CAN communication system

·

Combination meter sub-assembly


w/ Multi-information Display

PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if CAN communication system DTCs are output (see page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).

Result:
Result Proceed to
CAN communication system DTCs are output. A
CAN communication system DTCs are not output. B




A

B