The combination meter assembly controls the speedometer in accordance with vehicle speed signals from the ABS and traction actuator*1 (skid control ECU) or the brake actuator*2 (skid control ECU) through the CAN communication system.
*1: w/ VSC
*2: w/o VSC
If DTC U0129 has been stored, troubleshoot the CAN communication system first.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Perform the Active Test according to the prompts displayed on the tester.
| Item | Measurement Item / Range (Display) | Diagnostic Note |
|---|---|---|
| Speed Meter Operation | 0 / 40 / 80 / 120 / 160 / 200 / 240 km | Value selected during Active Test is displayed |
Vehicle speed displayed on the tester is almost the same as that of the speedometer reading.
OK
NG
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and the tester ON.
Read the Data List according to the prompts displayed on the tester.
| Item | Tester Details | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Vehicle Speed Meter | Vehicle speed / Min.: 0 km/h, Max.: 255 km/h | Almost same as actual vehicle speed (when driving) | - |
Almost same as actual vehicle speed (when driving).
OK
NG