The combination meter assembly controls the tachometer in accordance with engine speed signals from the ECM through the CAN communication system.
If DTC U0100 has been stored, troubleshoot the CAN communication system first.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Perform the Active Test according to the prompts displayed on the tester.
| Item | Tester Details | Diagnostic Note |
|---|---|---|
| TachoMeter Operation | 0 / 1,000 / 2,000 / 3,000 / 4,000 / 5,000 / 6,000 / 7,000 rpm | Value selected during Active Test is displayed |
Engine speed displayed on the tester is almost the same as that of the tachometer reading.
OK
NG
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Read the Data List according to the prompts displayed on the tester.
| Item | Measurement Item / Range (Display) | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Engine Rpm | Engine speed / Min.: 0 rpm, Max.: 12,750 rpm | Almost same as actual engine speed
(When engine is running) |
- |
Engine speed displayed on the tester is almost the same as the actual engine speed.
OK
NG