Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM
RM24M0E _56 Audio / Visual / Telematics _059588 NAVIGATION / MULTI INFO DISPLAY _0292199 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Mute Signal Circuit between Navigation Receiver Assembly and Television Display Assembly  


DESCRIPTION

The navigation receiver assembly controls the volume according to the mute signal from the television display assembly.

The mute signal is sent to reduce noise and popping sounds as such as those generated when switching modes. If there is an open in the circuit, noise can be heard from the speakers when changing the sound source. If there is a short in the circuit, even though the navigation receiver assembly is functioning normally, no sound or only an extremely faint sound can be heard.

WIRING DIAGRAM

E226158E79
1.212,1.108 1.653,1.271 0.441,0.163 10 MUTE 5.521,1.108 5.940,1.271 0.420,0.163 10 MUTE 1.738,0.978 1.914,1.117 0.177,0.139 10 6 5.355,0.978 5.453,1.117 0.098,0.139 10 6 0.666,1.969 0.961,2.125 0.295,0.156 10 Q21 0.666,2.117 1.789,2.453 1.123,0.336 10 Television Display Assembly 5.296,1.969 5.612,2.153 0.316,0.184 10 F2 5.296,2.117 6.561,2.453 1.265,0.336 10 Navigation Receiver Assembly

PROCEDURE

1.INSPECT TELEVISION DISPLAY ASSEMBLY
a.
U189952E02
1.958,1.833 2.146,2.438 false 0.156,0.083 0.365,0.302 0.208,0.219 10 false *a 1.594,0.729 1.958,0.927 0.365,0.198 10 false Q21 2.01,2.469 2.427,2.667 0.417,0.198 10 false MUTE

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
Q21-6 (MUTE) - Body ground Engine switch on (ACC), RSE system playing → Changing source Above 3.5 V → Below 1 V



Text in Illustration
*a Component with harness connected
(Television Display Assembly)


OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)
a.

Disconnect the F2 navigation receiver assembly connector.


b.

Disconnect the Q21 television display assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F2-6 (MUTE) - Q21-6 (MUTE) Always Below 1 Ω
F2-6 (MUTE) - Body ground Always 10 kΩ or higher




OK

3.REPLACE TELEVISION DISPLAY ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.REPLACE TELEVISION DISPLAY ASSEMBLY
a.

Replace the television display assembly and check if it operates normally (See page Audio / Visual / Telematics>AUDIO / VIDEO>TELEVISION DISPLAY>REMOVAL).

OK:

The navigation system operates normally.




OK

END

NG