Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM
RM24M0E _56 Audio / Visual / Telematics _059588 NAVIGATION / MULTI INFO DISPLAY _0292199 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  USB Audio System Recognition/Play Error  


DESCRIPTION

When a USB device or "iPod" is connected to the USB jack of the No. 1 stereo jack adapter assembly, it must have playable files. The device must also communicate with and be recognized by the navigation receiver assembly. This diagnosis procedure is for when a device is not recognized, or files from the device cannot be played normally.

WIRING DIAGRAM

E226163E77
0.829,1.169 1.295,1.390 0.466,0.221 10 UDO- 0.969,0.576 1.222,0.796 0.253,0.221 10 UPI 0.843,2.355 1.262,2.576 0.419,0.221 10 UJSG 0.815,1.776 1.234,1.997 0.419,0.221 10 UDO+ 0.829,2.956 1.248,3.177 0.419,0.221 10 UJSS 5.985,1.169 6.451,1.390 0.466,0.221 10 US1- 5.985,0.576 6.386,0.796 0.401,0.221 10 USV1 5.985,2.355 6.404,2.576 0.419,0.221 10 UGD1 5.985,1.776 6.404,1.997 0.419,0.221 10 US1+ 5.985,2.956 6.404,3.177 0.419,0.221 10 USG1 1.328,0.476 1.460,0.697 0.133,0.221 10 1 1.328,1.081 1.460,1.302 0.133,0.221 10 2 1.328,1.674 1.460,1.894 0.133,0.221 10 3 1.328,2.258 1.460,2.479 0.133,0.221 10 4 1.328,2.86 1.460,3.081 0.133,0.221 10 5 0.152,3.391 0.446,3.553 0.294,0.162 10 G99 0.152,3.537 1.832,3.868 1.680,0.331 10 No. 1 Stereo Jack Adapter Assembly 3.262,3.096 3.949,3.332 0.687,0.236 10 (Shielded) 5.769,0.476 5.902,0.697 0.133,0.221 10 1 5.769,1.075 5.902,1.296 0.133,0.221 10 2 5.769,1.674 5.902,1.894 0.133,0.221 10 3 5.769,2.258 5.902,2.479 0.133,0.221 10 4 5.769,2.86 5.902,3.081 0.133,0.221 10 5 5.686,3.391 6.050,3.553 0.364,0.162 10 G100 5.682,3.554 6.952,3.941 1.269,0.387 10 Navigation Receiver Assembly

CAUTION / NOTICE / HINT

NOTICE:

When replacing the navigation receiver assembly, perform vehicle contract setting (See page Audio / Visual / Telematics>G-BOOK>G-BOOK SYSTEM>REGISTRATION).


HINT:
·

When a large amount of data is in a USB device, it may take a while to begin play.

·

When using a USB device, files that are protected by copyright cannot be played.

·

When files are not played in the sorted order, perform the following procedure before inspection.

(a)

Add numbers in front of the file names.

(b)

Put the files in a folder and copy the folder data to the USB device.




PROCEDURE

1.CHECK USB DEVICE OR "iPod"
a.

Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.


b.

Check if playable files are present on the USB device or "iPod".

HINT:

Refer to System Description for playable files (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>SYSTEM DESCRIPTION).



c.

Check if the USB device is a compatible format or "iPod" is a compatible version.

HINT:

Refer to System Description for compatible formats and versions (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>SYSTEM DESCRIPTION).


Result:
Result Proceed to
No playable files exist, or incompatible device format or version A
Playable files exist, and compatible device format or version B




A

USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR NO PLAYABLE FILES PRESENT

B

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.
U189957E01
0.18,2.329 0.354,2.503 0.174,0.174 10 *b 1.572,2.33 1.922,2.481 0.351,0.151 10 G99 0.685,3.343 0.946,3.495 0.261,0.151 10 UPI 0.521,3.776 0.914,3.927 0.394,0.151 10 UDO- 0.18,0.162 0.354,0.335 0.174,0.174 10 *a 1.52,0.234 1.903,0.385 0.383,0.151 10 G100 1.491,3.43 1.002,3.43 false 0.641,1.51 1.056,1.662 0.415,0.151 10 US1+ 2.358,1.51 2.748,1.662 0.390,0.151 10 US1- 1.586,1.425 1.114,1.597 false 2.332,1.597 1.861,1.425 false 0.575,1.172 0.989,1.324 0.413,0.151 10 UGD1 1.586,1.257 1.081,1.257 false 2.464,3.343 2.861,3.495 0.397,0.151 10 UJSG 2.464,3.616 2.877,3.767 0.413,0.151 10 UDO+ 2.464,3.919 2.858,4.070 0.394,0.151 10 UJSS 2.445,3.43 1.956,3.43 false 2.442,1.172 2.880,1.324 0.438,0.151 10 USV1 2.303,1.854 2.706,2.005 0.404,0.151 10 USG1 2.423,1.257 1.861,1.257 false 1.618,3.447 1.002,3.84 false 1.831,3.447 2.445,3.69 false 1.782,3.545 2.445,3.981 false 1.784,1.552 2.281,1.928 false

Disconnect the G99 No. 1 stereo jack adapter assembly connector.


b.

Disconnect the G100 navigation receiver assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G99-1 (UPI) - G100-1 (USV1) Always Below 1 Ω
G99-2 (UDO-) - G100-2 (US1-) Always Below 1 Ω
G99-3 (UDO+) - G100-3 (US1+) Always Below 1 Ω
G99-4 (UJSG) - G100-4 (UGD1) Always Below 1 Ω
G99-5 (UJSS) - G100-5 (USG1) Always Below 1 Ω
G99-1 (UPI) - Body ground Always 10 kΩ or higher
G99-2 (UDO-) - Body ground Always 10 kΩ or higher
G99-3 (UDO+) - Body ground Always 10 kΩ or higher
G99-4 (UJSG) - Body ground Always 10 kΩ or higher
G99-5 (UJSS) - Body ground Always 10 kΩ or higher


Text in Illustration
*a Front view of wire harness connector
(to Navigation Receiver Assembly)
*b Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly)



OK

3.INSPECT NAVIGATION RECEIVER ASSEMBLY (NO. 1 STEREO JACK ADAPTER ASSEMBLY POWER SOURCE)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT NAVIGATION RECEIVER ASSEMBLY (NO. 1 STEREO JACK ADAPTER ASSEMBLY POWER SOURCE)
a.

Reconnect the G100 navigation receiver assembly connector.


b.
U189941E01
1.565,0.941 1.859,1.084 0.294,0.142 10 G99 1.955,2.084 2.549,2.297 false 1.495,2.084 0.851,2.304 false 2.566,2.27 2.987,2.415 0.422,0.145 10 UJSG 0.544,2.27 0.813,2.415 0.269,0.145 10 UPI 0.184,0.171 0.385,0.337 0.201,0.166 10 *a

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
G99-1 (UPI) - G99-4 (UJSG) Engine switch on (ACC) 5 V


Text in Illustration
*a Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly)



OK

4.FORMAT USB DEVICE OR RESTORE "iPod" AND RECHECK

NG

4.FORMAT USB DEVICE OR RESTORE "iPod" AND RECHECK
a.

Delete all files in the USB device or "iPod" and format/restore it.


b.

Save the data again and check if it can be played on the in-vehicle device.

NOTICE:

Formatting a USB device or restoring an "iPod" erases all music on the device. Ensure that backup music data is available before performing this operation.


OK:

Malfunction disappears.




OK

END

NG

5.REPLACE USB DEVICE OR "iPod"
5.REPLACE USB DEVICE OR "iPod"
a.

Turn the engine switch off.

HINT:

When this malfunction occurs, it is necessary to turn off the engine switch to make it possible for the vehicle to recognize a new device when it is connected.



b.

Turn the engine switch on (ACC).


c.

Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.


HINT:
·

If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.

·

Refer to System Description for compatible formats and versions (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>SYSTEM DESCRIPTION).




NEXT

6.CHECK USB DEVICE OR "iPod"
6.CHECK USB DEVICE OR "iPod"
a.

Check if a USB device or "iPod" is recognized by the navigation receiver assembly, and if information such as track, artist and album names are displayed on the screen.

OK:

Malfunction disappears.




OK

USB DEVICE OR "iPod" WAS INCOMPATIBLE OR DEFECTIVE

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE