Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM
RM24M0E _56 Audio / Visual / Telematics _059588 NAVIGATION / MULTI INFO DISPLAY _0292199 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal from a USB device to the navigation receiver assembly via this circuit.

WIRING DIAGRAM

E351352E02
0.344,2.823 1.531,3.271 1.188,0.448 10 false No. 1 Stereo Jack Adapter Assembly 0.344,2.667 0.635,2.865 0.292,0.198 10 false G99 0.875,2.208 1.323,2.427 0.448,0.219 10 false UJSS 0.854,1.438 1.302,1.656 0.448,0.219 10 false UDO+ 0.885,0.625 1.333,0.844 0.448,0.219 10 false UDO- 5.906,0.646 6.354,0.865 0.448,0.219 10 false US1- 5.906,1.458 6.354,1.677 0.448,0.219 10 false US1+ 5.906,2.208 6.313,2.417 0.406,0.208 10 false USG1 3.271,2.385 3.99,2.625 0.719,0.24 10 false (Shielded) 5.771,2.823 6.979,3.188 1.208,0.365 10 false Navigation Receiver Assembly 5.771,2.656 6.229,2.854 0.458,0.198 10 false G100 1.323,0.552 1.479,0.75 0.156,0.198 10 false 2 1.323,1.333 1.479,1.531 0.156,0.198 10 false 3 1.323,2.115 1.479,2.313 0.156,0.198 10 false 5 5.729,2.115 5.885,2.313 0.156,0.198 10 false 5 5.719,1.313 5.875,1.51 0.156,0.198 10 false 3 5.708,0.542 5.865,0.74 0.156,0.198 10 false 2

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.
U189958E01
0.18,2.25 0.354,2.423 0.174,0.174 10 *b 1.562,2.33 1.913,2.481 0.351,0.151 10 G99 0.521,3.616 0.914,3.767 0.394,0.151 10 UDO- 0.18,0.082 0.354,0.256 0.174,0.174 10 *a 1.519,0.234 1.915,0.385 0.397,0.151 10 G100 0.647,1.51 1.057,1.662 0.410,0.151 10 US1+ 2.368,1.51 2.757,1.662 0.390,0.151 10 US1- 1.586,1.425 1.114,1.58 false 2.332,1.58 1.861,1.425 false 2.464,3.616 2.877,3.767 0.413,0.151 10 UDO+ 2.464,3.919 2.858,4.070 0.394,0.151 10 UJSS 2.303,1.854 2.706,2.005 0.404,0.151 10 USG1 1.618,3.447 1.002,3.68 false 1.831,3.447 2.445,3.69 false 1.782,3.545 2.445,3.981 false 1.784,1.552 2.281,1.928 false

Disconnect the G100 navigation receiver assembly connector.


b.

Disconnect the G99 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G100-2 (US1-) - G99-2 (UDO-) Always Below 1 Ω
G100-3 (US1+) - G99-3 (UDO+) Always Below 1 Ω
G100-5 (USG1) - G99-5 (UJSS) Always Below 1 Ω
G100-2 (US1-) - Body ground Always 10 kΩ or higher
G100-3 (US1+) - Body ground Always 10 kΩ or higher
G100-5 (USG1) - Body ground Always 10 kΩ or higher


Text in Illustration
*a Front view of wire harness connector
(to Navigation Receiver Assembly)
*b Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly)



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR