These DTCs are stored if there is a malfunction in the CAN communication system connected to the navigation receiver assembly.
If CAN communication system DTCs are stored, they may also be stored in other systems.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0126 | Lost communication with steering sensor | CAN communication system |
| U0140 | Lost communication with main body ECU (instrument panel junction block assembly) |
Clear the DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTCs are output | A |
| No DTCs are output | B |
If CAN communication system DTCs are stored, they may also be stored in other systems.
If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.
If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING).
A
B
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)