This DTC is stored when the navigation receiver assembly judges that the back camera initial setting has not been memorized (rear television camera optical axis adjustment is incomplete).
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1691 | Back camera initial setting has not been memorized | ·
Rear television camera optical axis adjustment ·
Navigation receiver assembly |
When "System initializing" is displayed on the navigation receiver assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>INITIALIZATION).
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION).
Perform the following procedure depending on the memory conditions to register the vehicle information into the navigation receiver assembly.
Rear television camera optical axis adjustment (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION).
NEXT
Clear the DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1691 is output | A |
| No DTCs are output | B |
If DTC C1691 is output, perform the rear television camera assembly optical axis adjustment again.
If DTC C1691 is still output after performing the rear television camera assembly optical axis adjustment 3 times, replace the navigation receiver assembly.
A
B