Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM
RM24M0E _56 Audio / Visual / Telematics _059590 PARK ASSIST / MONITORING _0292203 PARKING ASSIST MONITOR SYSTEM C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM  C1694  Steering Angle Initialization Incomplete  


SYSTEM DESCRIPTION

This DTC is stored when the navigation receiver assembly judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).

DTC No. DTC Detection Condition Trouble Area
C1694 Maximum steering angle has not been memorized
·

Steering angle setting

·

Navigation receiver assembly



CAUTION / NOTICE / HINT

NOTICE:
·

When "System initializing" is displayed on the navigation receiver assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION).



PROCEDURE

1.PERFORM SETTINGS
a.

Perform the following to steering angle setting into the navigation receiver assembly.




NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT

b.

Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC C1694 is output A
No DTCs are output B


HINT:
·

If DTC C1694 is output, perform the steering angle setting again.

·

If DTC C1694 is still output after performing the steering angle setting 3 times, replace the navigation receiver assembly.





A

B

END