89342A
1.INSTALL REAR CENTER ULTRASONIC SENSOR
Use the same procedure for the RH side and LH side.
Engage the 4 claws to install the rear center ultrasonic sensor as shown in the illustration.
| *a | Keyhole | - | - |
Do not damage the rear bumper assembly.
Do not damage the rear center ultrasonic sensor.
Align the keyhole and the connector of the rear center ultrasonic sensor as shown in the illustration.
When pressing the rear center ultrasonic sensor to engage the claws, apply force perpendicular to the rear bumper assembly.
While pressing the rear center ultrasonic sensor from the outside of the rear bumper assembly, connect the connector.
After connecting the connector, press the rear center ultrasonic sensor from the outside of the rear bumper assembly.
89342
2.INSTALL REAR CORNER ULTRASONIC SENSOR
Use the same procedure for the RH side and LH side.
Engage the 4 claws to install the rear corner ultrasonic sensor as shown in the illustration.
| *a | Keyhole | - | - |
Do not damage the rear bumper assembly.
Do not damage the rear corner ultrasonic sensor.
Align the keyhole and the connector of the rear corner ultrasonic sensor as shown in the illustration.
When pressing the rear corner ultrasonic sensor to engage the claws, apply force perpendicular to the rear bumper assembly.
89348D
3.INSTALL ULTRASONIC SENSOR CLIP (for Corner Sensor)
Use the same procedure for the RH side and LH side.
Engage the 2 claws to install the ultrasonic sensor clip.
Engage the clamp.
While pressing the rear corner ultrasonic sensor from the outside of the rear bumper assembly, connect the connector.
After connecting the connector, press the rear corner ultrasonic sensor from the outside of the rear bumper assembly.
4.INSTALL REAR BUMPER ASSEMBLY