1.REMOVE REAR BUMPER ASSEMBLY
89348D
2.REMOVE ULTRASONIC SENSOR CLIP (for Corner Sensor)
for Type A:
Disconnect the connector.
| *A | for LH Side |
| *B | for RH Side |
Disengage the clamp.
Disengage the 4 claws to remove the ultrasonic sensor clip.
| *A | for LH Side |
| *B | for RH Side |
for Type B:
Disconnect the connector.
| *A | for LH Side |
| *B | for RH Side |
Disengage the clamp.
Disengage the 2 claws to remove the ultrasonic sensor clip.
| *A | for LH Side |
| *B | for RH Side |
89341A
3.REMOVE NO. 1 ULTRASONIC SENSOR (for Corner Sensor)
for Type A:
Disengage the 2 claws to remove the No. 1 ultrasonic sensor.
| *A | for LH Side |
| *B | for RH Side |
for Type B:
Use the same procedure for the RH side and LH side.
Disengage the 4 claws and remove the No. 1 ultrasonic sensor as shown in the illustration.
89348
4.REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (for Corner Sensor)
for Type A:
Disengage the 2 claws to remove the No. 1 ultrasonic sensor retainer from the rear bumper assembly.
| *A | for LH Side |
| *B | for RH Side |
89341A
5.REMOVE NO. 1 ULTRASONIC SENSOR (for Back Sensor)
Use the same procedure for the RH side and LH side.
for Type A:
Disconnect the connector.
Disengage the 2 claws to remove the No. 1 ultrasonic sensor.
for Type B:
Disconnect the connector.
Disengage the 4 claws and remove the No. 1 ultrasonic sensor as shown in the illustration.
89348A
6.REMOVE NO. 2 ULTRASONIC SENSOR RETAINER (for Back Sensor)
Use the same procedure for the RH side and LH side.
for Type A:
Disengage the 2 claws to remove the No. 2 ultrasonic sensor retainer from the rear bumper assembly.